XC164CM_04 Datasheet, PDF (13/14 Pages) Infineon Technologies AG – 16-Bi t Single-Chip Microcontroller

XC164CM-8FF
Delta Sheet XC164CM-8FF to XC164CS-16FF
Table 4
Pin Definitions and Functions (cont’d)
Symbol Pin Input Function
Num. Outp.
P5
I
P5.0 9
I
P5.1 10 I
P5.2 11 I
P5.3 12 I
P5.4 13 I
P5.5 14 I
P5.10 15 I
P5.11 16 I
P5.6 17 I
P5.7 18 I
P5.12 21 I
P5.13 22 I
P5.14 23 I
P5.15 24 I
Port 5 is a 14-bit input-only port.
The pins of Port 5 also serve as analog input channels for the
A/D converter, or they serve as timer inputs:
AN0
AN1
AN2
AN3
AN4
AN5
AN10,
T6EUD GPT2 Timer T6 Ext. Up/Down Ctrl. Inp.
AN11,
T5EUD GPT2 Timer T5 Ext. Up/Down Ctrl. Inp.
AN6
AN7
AN12,
T6IN GPT2 Timer T6 Count/Gate Input
AN13,
T5IN GPT2 Timer T5 Count/Gate Input
AN14,
T4EUD GPT1 Timer T4 Ext. Up/Down Ctrl. Inp.
AN15,
T2EUD GPT1 Timer T2 Ext. Up/Down Ctrl. Inp.
V_AREF
V_AGND
V_DDI
19 -
20 -
26, 58 -
Reference voltage for the A/D converter.
Reference ground for the A/D converter.
Core Supply Voltage (On-Chip Modules):
+2.5 V during normal operation and idle mode.
Please refer to the Operating Conditions
V_DDP 8, 27, -
40, 57
Pad Supply Voltage (Pin Output Drivers):
+5 V during normal operation and idle mode.
Please refer to the Operating Conditions
V_SS 7, 25, -
41, 59
Ground.
Connect decoupling capacitors to adjacent V_DDx/V_SS pin
pairs as close as possible to the pins.
All V_SS pins must be connected to the ground-line or ground-
plane.
1) _{The CAN interface lines are assigned to port P9 under software control.}
2) _{If at the end of an external reset TRST was high these pins are used for sensing configuration settings and}
integrated pull up devices are activated during reset.
Draft Delta Sheet
9
V1.0D3, 2004-03