TLE6288R Datasheet, PDF (13/23 Pages) Infineon Technologies AG – Smart 6 Channel Peak&Hold Switch

Preliminary Datasheet TLE6288 R
V_CC = 4.5 to 5.5 V ; T_j = - 40 °C to + 150 °C ; V_B = 6V to 16V ; Reset = H ; V_DO = V_CC
(unless otherwise specified)
No. Parameter
Sym Condition Value
Unit
bol
min typ max
Pin /
Comment
6 SPI Timing
6.1 Serial Clock Frequency (de-
f_SCK
pending on SO load)
6.2 Serial Clock Period (1/fclk)
t_p(SCK)
DC -- 5
MHz
200 -- -- ns
6.3 Serial Clock High Time
t_SCKH
50 -- -- ns
6.4 Serial Clock Low Time
t_SCKL
50 -- -- ns
6.5 Enable Lead Time
t_leadL CLKProg=L 200 -- --
ns
(falling edge of CS to falling
edge of SCLK)
Enable Lead Time
(falling edge of CS to rising
edge of SCLK)
t_leadH CLKProg=H 200 -- --
ns
6.6 Enable Lag Time (rising edge of tlagL CLKProg=L 200 --- --
ns
SCLK to rising edge of CS )
Enable Lag Time (falling edge t_lagH CLKProg=H 200 --- --
ns
of SCLK to rising edge of CS )
6.7 Data Setup Time (required time tSUL CLKProg=L 20 -- --
ns
SI to rising of SCLK)
Data Setup Time (required time t_SUH CLKProg=H 20 -- --
ns
SI to falling of SCLK)
6.8 Data Hold Time (rising edge of tHL
CLKProg=L 20 -- --
ns
SCLK to SI)
Data Hold Time (falling edge of t_HH CLKProg=H 20 -- --
ns
SCLK to SI)
6.9 Disable Time
t_DIS
-- 200 ns
6.10 Transfer Delay Time²
t_dt
200 -- -- ns
( CS high time between two
accesses)
6.11 Data Valid Time
t_valid
C_L = 50 pF to 100pF
C_L = 220 pF
ns
-- -- 120
-- -- 150
1)_{To get the correct diagnostic information, the transfer delay time has to be extended to the maximum fault delay}
time t_f(fault)max = 200µs.
Vp2
Page 13
13.01.2003