ICE2A380P2 Datasheet, PDF (12/20 Pages) Infineon Technologies AG – Off-Line SMPS Current Mode Controller with integrated 800V CoolMOS™

CoolSET™-F2
ICE2A380P2
Functional Description
V_Gate ca. t = 130ns
5V
t
Figure 17 Internal Gate Rising Slope
Overload / Open Loop with Normal Load
5µs Blanking
FB
4.8V
Failure
Detection
t
SoftS
5.3V
Soft-Start Phase
3.8
Protection Unit (Auto Restart Mode)
An overload, open loop and overvoltage detection is
integrated within the Protection Unit. These three
failure modes are latched by an Error-Latch. Additional
thermal shutdown is latched by the Error-Latch. In case
of those failure modes the Error-Latch is set after a
blanking time of 5µs and the CoolMOS™ is shut down.
That blanking prevents the Error-Latch from distortions
caused by spikes during operation mode.
3.8.1
Overload / Open Loop with Normal
Load
Figure 18 shows the Auto Restart Mode in case of
overload or open loop with normal load. The detection
of open loop or overload is provided by the Comparator
C3, C4 and the AND-gate G2 (see Figure 19). The
detection is activated by C4 when the voltage at pin
SoftS exceeds 5.3V. Till this time the IC operates in the
Soft-Start Phase. After this phase the comparator C3
can set the Error-Latch in case of open loop or overload
which leads the feedback voltage V_FB to exceed the
threshold of 4.8V. After latching VCC decreases till
8.5V and inactivates the IC. At this time the external
Soft-Start capacitor is discharged by the internal
transistor T1 due to Power Down Reset. When the IC
is inactive V_VCC increases till V_CCon = 13.5V by charging
the Capacitor C_VCC by means of the Start-Up Resistor
R_Start-Up. Then the Error-Latch is reset by Power Up
Reset and the external Soft-Start capacitor C_Soft-Start is
charged by the internal pull-up resistor R_Soft-Start. During
the Soft-Start Phase which ends when the voltage at
pin SoftS exceeds 5.3V the detection of overload and
open loop by C3 and G2 is inactive. In this way the Start
Up Phase is not detected as an overload.
Driver
T_Burst1
t
T_Restart
t
VCC
13.5V
8.5V
t
Figure 18 Auto Restart Mode
6.5V
Power Up Reset
SoftS
R_Soft-Start
C_Soft-Start
T1
FB
C4
5.3V
4.8V
C3
Error-Latch
G2
R_FB
6.5V
Version 0.0
Figure 19 FB-Detection
12
23 Sep 2004