BTS5016-2EKA Datasheet, PDF (12/54 Pages) Infineon Technologies AG – Smart High-Side Power Switch

BTS5016-2EKA
General Product Characteristics
Table 3 Functional Range (cont’d)T_J = -40 °C to +150 °C; (unless otherwise specified)
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Maximum standby current for I_{S(OFF)_150} –
7
30
μA V_S = 18 V
whole device with load
V_OUT = 0 V
V_IN floating
V_DEN floating
T_J = 150 °C
See Figure 33
Standby current for whole
I_{S(OFF_DEN)} –
device with load, diagnostic
active
0.6 –
1) Test at T_J = -40°C only
2) Not subject to production test. Specified by design.
mA ²⁾ V_S = 18 V
V_OUT = 0 V
V_IN floating
V_DEN = 5.5 V
Number
P_4.2.10
P_4.2.8
Note: Within the functional range the IC operates as described in the circuit description. The electrical
characteristics are specified within the conditions given in the related electrical characteristics table.
4.3
Thermal Resistance
Table 4 Thermal Resistance
Parameter
Symbol
Junction to soldering point
Junction to ambient
Both channels active
R_thJS
R_thJA
Min.
–
–
Values
Typ. Max.
5
–
26
–
Unit
K/W
K/W
Note /
Test Condition
1)
1) 2)
Number
P_4.3.1
P_4.3.2
1) Not subject to production test. Specified by design.
2)Specified R_thja value is according to JEDEC JESD51-2,-5,-7 at natural convection on FR4 2s2p board; The
product (chip + package) was simulated on a 76.4 x 114.3 x 1.5 mm board with 2 inner copper layers (2 x 70μm
Cu, 2 x 35 μm Cu). Where applicable, a thermal via array under the exposed pad contacts the first inner copper
layer. Please refer to Figure 4 and Figure 5.
4.3.1 PCB set up
1.5mm
Figure 4 2s2p PCB Cross Section
Data Sheet
PROFET™+ 12V
0.3mm
12
70µm
35µm
PCB 2s2p.vsd
Rev 1.0, 2013-06-17