V23848-H18-C56 Datasheet, PDF (10/30 Pages) Infineon Technologies AG – iSFP-Intelligent Small Form-factor Pluggable SONET OC-12/OC-3 IR-1 / SDH STM S-4.1/S-1.1 Multirate Applications up to 622 Mbit/s

V23848-H18-C56
V23848-H19-C56
Technical Data
Optical Characteristics (V_CC = 2.97 V to 3.63 V, T_C = –40°C to 85°C)
Parameter
Symbol
Values
Unit
min.
typ.
max.
Transmitter
Launched Power (Average)¹⁾ P_O
–15
Extinction Ratio (Dynamic)
ER
8.2
–8
dBm
dB
Center Wavelength
Spectral Width (rms)
Tx Disable Laser Output Power
Optical Eye Mask²⁾
λ_C
σ_I
P_O-TxDis
1274
1356
2.5
–50
According to standards
nm
nm
dBm
Jitter Generation (pk-pk)³⁾
Jitter Generation (rms)³⁾
Rise Time⁴⁾
Fall Time⁴⁾
Receiver⁵⁾
J_{pk-pk Tx}
J_{rms Tx}
t_R-Tx
t_F-Tx
0.055
0.003
40
150
0.065 UI
0.0045 UI
ps
ps
Saturation (Average Power)⁶⁾ P_SAT
–8
Sensitivity (Average Power)⁷⁾ P_IN
@ 622 Mbit/s
@ 155 Mbit/s
@ 125 Mbit/s
–30.5 –28
–31.5 –28
–31.5 –28
dBm
dBm
LOS Assert Level⁸⁾
LOS Deassert Level⁸⁾
LOS Hysteresis⁸⁾
Input Center Wavelength
Path Penalty
P_LOSA
–37
P_LOSD
P_LOSA
0.5
3
–P_LOSD
λ_C
1260
Rx_PEN
–28
1580
1
dBm
dBm
dB
nm
dB
1) _{Into single mode fiber, 9 µm diameter.}
2) _{Transmitter eye is according to ITU-T G.957 S-4.1 and SONET OC-12 IR-1. Measured with 20% eye mask}
margin.
3) _{The transceiver is specified to meet the SONET/SDH Jitter performance as outlined in ITU-T G.958 and}
Telcordia GR-253. Jitter Generation is defined as the amount of jitter that is generated by the transceiver. The
Jitter Generation specifications are referenced to the optical OC-12 signals. If no or minimum jitter is applied
to the electrical inputs of the transmitter, then Jitter Generation can simply be defined as the amount of jitter
on the Tx optical output. The SONET specifications for Jitter Generation are 0.01 UI rms, maximum and 0.1
UI pk-pk, maximum. For SDH, 10 mUI rms, maximum. Both are measured with a 12 kHz - 5 MHz filter in line.
A UI is a Unit Interval, which is equivalent to one bit slot.
4) _{Values are 20% - 80%, filtered and measured at nominal data rate.}
5) _{Receiver characteristics are measured with a worst case reference laser.}
6) _{At 9 dB Extinction Ratio of the incoming signal.}
Data Sheet
10
2004-06-25