English
Language : 

843S1066D Datasheet, PDF (6/15 Pages) Integrated Device Technology – Crystal-to-3.3V LVPECL Frequency Synthesizer
Application Information
Power Supply Filtering Technique
As in any high speed analog circuitry, the power supply pins are
vulnerable to random noise. To achieve optimum jitter performance,
power supply isolation is required. The 843S1066D provides
separate power supplies to isolate any high switching noise from the
outputs to the internal PLL. VCC and VCCA should be individually
connected to the power supply plane through vias, and 0.01µF
bypass capacitors should be used for each pin. Figure 1 illustrates
this for a generic VCC pin and also shows that VCCA requires that an
additional 10 resistor along with a 10F bypass capacitor be
connected to the VCCA pin.
843S1066D Datasheet
3.3V
VCC
0.01μF
VCCA
0.01μF 10μF
Figure 1. Power Supply Filtering
Crystal Input Interface
The 843S1066D has been characterized with 18pF parallel resonant
crystals. The capacitor values, C1 and C2, shown in Figure 2 below
were determined using a 20MHz, 18pF parallel resonant crystal and
were chosen to minimize the ppm error. The optimum C1 and C2
values can be slightly adjusted for different board layouts. External
tuning capacitor must be used for proper operation.
X1
18pF Parallel Crystal
C1
28pF
XTAL_IN
C2
28pF
XTAL_OUT
Figure 2. Crystal Input Interface
©2016 Integrated Device Technology, Inc.
6
Revision B, November 10, 2016