|
ICS91730 Datasheet, PDF (4/11 Pages) Integrated Circuit Systems – Low EMI, Spread Modulating, Clock Generator | |||
|
◁ |
ICS91730
LOW EMI, SPREAD MODULATING, CLOCK GENERATOR
General SMBus Serial Interface Information
How to Write
⢠Controller (host) sends a start bit
⢠Controller (host) sends the write address
⢠IDT clock will acknowledge
⢠Controller (host) sends the beginning byte location = N
⢠IDT clock will acknowledge
⢠Controller (host) sends the byte count = X
⢠IDT clock will acknowledge
⢠Controller (host) starts sending Byte N through Byte
N+X-1
⢠IDT clock will acknowledge each byte one at a time
⢠Controller (host) sends a Stop bit
Index Block Write Operation
Controller (Host)
T
starT bit
IDT (Slave/Receiver)
Slave Address
WR
WRite
ACK
Beginning Byte = N
ACK
Data Byte Count = X
ACK
Beginning Byte N
ACK
O
O
O
O
O
O
Byte N + X - 1
ACK
P
stoP bit
Read Address
D5(H)
Write Address
D4(H)
How to Read
⢠Controller (host) will send a start bit
⢠Controller (host) sends the write address
⢠IDT clock will acknowledge
⢠Controller (host) sends the beginning byte location = N
⢠IDT clock will acknowledge
⢠Controller (host) will send a separate start bit
⢠Controller (host) sends the read address
⢠IDT clock will acknowledge
⢠IDT clock will send the data byte count = X
⢠IDT clock sends Byte N+X-1
⢠IDT clock sends Byte 0 through Byte X (if X(H) was
written to Byte 8)
⢠Controller (host) will need to acknowledge each byte
⢠Controller (host) will send a not acknowledge bit
⢠Controller (host) will send a stop bit
Index Block Read Operation
Controller (Host)
T
starT bit
IDT (Slave/Receiver)
Slave Address
WR
WRite
ACK
Beginning Byte = N
ACK
RT
Repeat starT
Slave Address
RD
ReaD
ACK
ACK
ACK
O
O
O
N
Not acknowledge
P
stoP bit
Data Byte Count=X
Beginning Byte N
O
O
O
Byte N + X - 1
IDT® LOW EMI, SPREAD MODULATING, CLOCK GENERATOR
4
ICS91730
REV F 061611
|
▷ |