ICS571 Datasheet, PDF (3/7 Pages) Integrated Circuit Systems – Low Phase Noise Zero Delay Buffer

ICS571
LOW PHASE NOISE ZERO DELAY BUFFER
ZDB AND MULTIPLIER/DIVIDER
External Components
The ICS571 requires a minimum number of external
components for proper operation.
A decoupling capacitor of 0.01µF must be connected
between VDD and GND on each side of the chip (between
pins 2 and 3, and between pins 6 and 5). They must be
connected close to the ICS571 to minimize lead inductance.
No external power supply filtering is required for this device.
A 33Ω terminating resistor can be used next to each output
pin.
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the ICS571. These ratings, which are
standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these
or any other conditions above those indicated in the operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical
parameters are guaranteed only over the recommended operating temperature range.
Item
Supply Voltage, VDD, referenced to GND
Inputs, referenced to GND
Clock Output, referenced to GND
Storage Temperature
Soldering Temperature, max of 10 seconds
Ambient Operating Temperature
Rating
7V
-0.5 V to VDD+0.5 V
-0.5 V to VDD+0.5 V
-65 to +150° C
260° C
0 to +70° C
IDT™ / ICS™ LOW PHASE NOISE ZERO DELAY BUFFER
3
ICS571
REV H 051310