ICS843081I-01 Datasheet, PDF (7/15 Pages) Integrated Circuit Systems – FEMTOCLOCKS™ CRYSTAL-TO-3.3V, 2.5V LVPECL CLOCK MULTIPLIER

Integrated
Circuit
Systems, Inc.
ICS843081I-01
FEMTOCLOCKS™ CRYSTAL-TO-
3.3V, 2.5V LVPECL CLOCK MULTIPLIER
APPLICATION INFORMATION
POWER SUPPLY FILTERING TECHNIQUES
As in any high speed analog circuitry, the power supply pins
are vulnerable to random noise. The ICS843081I-01 provides
separate power supplies to isolate any high switching
noise from the outputs to the internal PLL. V_CC and V_CCA should
be individually connected to the power supply
plane through vias, and bypass capacitors should be
used for each pin. To achieve optimum jitter performance,
power supply isolation is required. Figure 1 illustrates how
a 10Ω resistor along with a 10μF and a .01μF bypass
capacitor should be connected to each V_CCA pin. The 10Ω
resistor can also be replaced by a ferrite bead.
V_CC
V_CCA
3.3V or 2.5V
.01μF 10Ω
.01μF
10μF
FIGURE 1. POWER SUPPLY FILTERING
CRYSTAL INPUT INTERFACE
The ICS843081I-01 has been characterized with 18pF parallel
resonant crystals. The capacitor values, C1 and C2, shown in
Figure 2 below were determined using an 18pF parallel reso-
nant crystal and were chosen to minimize the ppm error. The
optimum C1 and C2 values can be slightly adjusted for different
board layouts.
X1
18pF Parallel Crystal
XTAL_OUT
C1
33p
XTAL_IN
C2
22p
ICS843081I-01
Figure 2. CRYSTAL INPUt INTERFACE
843081AGI-01
www.icst.com/products/hiperclocks.html
7
REV. B JANUARY 23, 2006