ICS85301 Datasheet, PDF (10/19 Pages) Integrated Circuit Systems – 2:1 DIFFERENTIAL-TO-LVPECL MULTIPLEXER

Integrated
Circuit
Systems, Inc.
RECOMMENDATIONS FOR UNUSED INPUT PINS
INPUTS:
PCLK/nPCLK INPUT:
For applications not requiring the use of a differential input,
both the PCLK and nPCLK pins can be left floating. Though
not required, but for additional protection, a 1kΩ resistor can
be tied from PCLK to ground.
ICS85301
2:1
DIFFERENTIAL-TO-LVPECL MULTIPLEXER
TERMINATION FOR 3.3V LVPECL OUTPUT
The clock layout topology shown below is a typical termi-
nation for LVPECL outputs. The two different layouts men-
tioned are recommended only as guidelines.
FOUT and nFOUT are low impedance follower outputs that
generate ECL/LVPECL compatible outputs. Therefore, ter-
minating resistors (DC current path to ground) or current
sources must be used for functionality. These outputs are
designed to drive 50Ω transmission lines. Matched imped-
ance techniques should be used to maximize operating
frequency and minimize signal distortion. Figures 3A and
3B show two different layouts which are recommended only
as guidelines. Other suitable clock layouts may exist and it
would be recommended that the board designers simulate
to guarantee compatibility across all printed circuit and clock
component process variations.
Z_o = 50Ω
FOUT
FIN
Z_o = 50Ω
50Ω
RTT =
1
((V_OH + V_OL) / (V_CC – 2)) – 2
Z_o
50Ω
V_CC - 2V
RTT
FOUT
3.3V
125Ω
125Ω
Z_o = 50Ω
FIN
Z_o = 50Ω
84Ω
84Ω
FIGURE 3A. LVPECL OUTPUT TERMINATION
FIGURE 3B. LVPECL OUTPUT TERMINATION
85301AK
www.icst.com/products/hiperclocks.html
10
REV. A JANUARY 16, 2006