X24C02 Datasheet, PDF (9/16 Pages) Xicor Inc. – Serial E2PROM

X24C02
ABSOLUTE MAXIMUM RATINGS*
Temperature Under Bias .................. –65°C to +135°C
Storage Temperature ....................... –65°C to +150°C
Voltage on any Pin with
Respect to V _SS ................................ –1.0V to +7.0V
D.C. Output Current ............................................ 5 mA
Lead Temperature (Soldering, 10 Seconds) ..... 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation of
the device at these or any other conditions above those
indicated in the operational sections of this specification is not
implied. Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Min.
Max.
Commercial
Industrial
Military
0°C
–40°C
–55°C
70°C
+85°C
+125°C
3838 PGM T09
Supply Voltage
X24C02
X24C02-3.5
X24C02-3
X24C02-2.7
Limits
4.5V to 5.5V
3.5V to 5.5V
3V to 5.5V
2.7 to 5.5V
3838 PGM T10
D.C. OPERATING CHARACTERISTICS (Over recommended operating conditions unless otherwise specified).
Symbol
l_CC1
l_CC2
I_SB(1)
I_SB(2)
I_LI
I_LO
V_lL(2)
V_IH(2)
V_OL
Parameter
Power Supply Current (read)
Power Supply Current (write)
Standby Current
Limits
Min.
Max.
1
2
50
Standby Current
30
Input Leakage Current
Output Leakage Current
Input Low Voltage
Input High Voltage
Output Low Voltage
10
10
–1.0 V_CC x 0.3
V_CC x 0.7V_CC + 0.5
0.4
Units
Test Conditions
mA _{SCL = VCC x 0.1/VCC x 0.9 Levels @ 100}
KHz, SDA = Open, All Other
Inputs = GND or V_CC – 0.3V
∝A _{SCL = SDA = VCC – 0.3V, All other}
Inputs = GND or V_CC, V_CC = 5.5V
∝A _{SCL = SDA = VCC – 0.3V, All Other}
Inputs = GND or V_CC = 3.3V + 10%
∝A _{VIN = GND to VCC}
∝A _{VOUT = GND to VCC}
V
V
V I_OL = 3 mA
3838 PGM T02
CAPACITANCE T_A = 25°C, f = 1 MHz, V_CC = 5V
Symbol
Parameter
C (3)
I/O
C_IN(3)
Input/Output Capacitance (SDA)
Input Capacitance (A₀, A₁, A₂, SCL, WC)
Notes:(1)Must perform a stop command prior to measurement.
(2)VIL min. and VIH max. are for reference only and are not tested. (3)This
parameter is periodically sampled and not 100% tested.
Max.
8
6
Units
pF
pF
Test Conditions
V_I/O = 0V
V_IN = 0V
3838 PGM T04
9