X76F400 Datasheet, PDF (8/14 Pages) IC MICROSYSTEMS – Secure SerialFlash

X76F400
ABSOLUTE MAXIMUM RATINGS
Temperature under bias....................–65°C to +135°C
Storage temperature ........................–65°C to +150°C
Voltage on any pin with
respect to V _SS ......................................... –1V to +7V
D.C. output current............................................... 5mA
Lead temperature (soldering, 10 seconds).........300°C
RECOMMENDED OPERATING CONDITIONS
Temperature
Commercial
Industrial
Min.
0°C
–40°C
Max.
+70°C
+85°C
COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only; functional operation of the
device (at these or any other conditions above those
listed in the operational sections of this specification) is not
implied. Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
Supply Voltage
X76F400
X76F400 – 2.5
Limits
4.5V to 5.5V
2.5V to 5.5V
D.C. OPERATING CHARACTERISTICS (Over the recommended operating conditions unless otherwise specified.)
Symbol
I _CC1
I_CC2⁽³⁾
I_SB1⁽¹⁾
I_SB2⁽¹⁾
I_LI
I_LO
V_IL⁽²⁾
V_IH⁽²⁾
V_OL
Parameter
V_CC Supply current
(Read)
Limits
Min.
Max.
1
V_CC Supply current
3
(Write)
V_CC Supply current
1
(Standby)
V_CC Supply current
1
(Standby)
Input leakage current
10
Output leakage current
Input LOW voltage
Input HIGH voltage
Output LOW voltage
–0.5
V_CC x 0.9
10
V_CC x 0.1
V_CC + 0.5
0.4
Unit
mA
mA
µA
µA
µA
µA
V
V
V
Test Conditions
f_SCL = V_CC x 0.1/V_CC x 0.9 Levels @ 400 kHz,
SDA = Open
RST = V _SS
f_SCL = V_CC x 0.1/V_CC x 0.9 Levels @ 400 kHz,
SDA = Open
RST = V _SS
V_IL = V_CC x 0.1, V_IH = V_CC x 0.9
f_SCL = 400 kHz, f_SDA = 400 kHz
V_SDA = V_SCC = V_CC
Other = GND or V_CC–0.3V
V_IN = V_SS to V_CC
V_OUT = V_SS to V_CC
I_OL = 3mA
CAPACITANCE T_A = +25°C, f = 1MHz, V_CC = 5V
Symbol
Test
C_OUT⁽³⁾
C_IN⁽³⁾
Output capacitance (SDA)
Input capacitance (RST, SCL)
Max.
8
6
Unit
pF
pF
Conditions
V_I/O = 0V
V_IN = 0V
Notes: _{(1)Must perform a stop command after a read command prior to measurement (2)V}
IL ^{min. and V}IH max. are for reference only and are not tested
(3)This parameter is periodically sampled and not 100% test
REV 1.0 7/5/00
www.icmic.com
Characteristics subject to change without notice. 8 of 14