X25170 Datasheet, PDF (8/15 Pages) IC MICROSYSTEMS – SPI Serial E 2 PROM with Block Lock ™ Protection

X25170
ABSOLUTE MAXIMUM RATINGS
Temperature under bias ........................–65 to +135°C
Storage temperature .............................–65 to +150°C
Voltage on any pin with respect to V_SS....... –1V to +7V
D.C. output current ............................................... 5mA
Lead temperature (soldering, 10 seconds).........300°C
RECOMMENDED OPERATING CONDITIONS
Temperature
Commercial
Industrial
Military
Min.
0°C
–40°C
–55°C
Max.
+70°C
+85°C
+125°C
COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only; functional operation of the
device (at these or any other conditions above those
listed in the operational sections of this specification) is
not implied. Exposure to absolute maximum rating con-
ditions for extended periods may affect device reliability.
Supply Voltage
X25170
X25170-2.5
Limits
5V ±10%
2.5V to 5.5V
D.C. OPERATING CHARACTERISTICS(Over the recommended operating conditions unless otherwise specified.)
Symbol
I_CC
I_SB
I_LI
I_LO
V_IL⁽¹⁾
V_IH⁽¹⁾
V_OL1
V_OH1
V_OL2
V_OH2
Parameter
V_CC supply current (active)
V_CC supply current (standby)
Input leakage current
Output leakage current
Input LOW voltage
Input HIGH voltage
Output LOW voltage
Output HIGH voltage
Output LOW voltage
Output HIGH voltage
Limits
Min.
Max.
5
Units
mA
1
µA
10
µA
10
µA
–1
V_CC x 0.3 V
V_CC x 0.7 V_CC + 0.5 V
0.4
V
V_CC–0.8
V
0.4
V
V_CC–0.3
V
Test Conditions
SCK = V_CC x 0.1/V_CC x 0.9 @ 2MHz,
SO = Open, CS = V_SS
SO = Open, CS = V_SS
SO = Open, CS = V_SS
CS = V_CC, V_IN = V_SS or V_CC
V_IN = V_SS to V_CC
V_OUT = V_SS to V_CC
V_CC = 5V, I_OL = 3mA
V_CC = 5V, I_OH = -1.6mA
V_CC = 2.70V, I_OL = 1.5mA
V_CC = 2.70V, I_OH = -0.4mA
POWER-UP TIMING
Symbol
T_PUR⁽³⁾
T_PUW⁽³⁾
Parameter
Power-up to read operation
Power-up to write operation
Min.
Max.
1
1
Units
ms
ms
Characteristics subject to change without notice. 8 of 15