X24165 Datasheet, PDF (4/17 Pages) Xicor Inc. – Advanced 2-Wire Serial E2PROM with Block Lock Protection

X24165
Stop Condition
All communications must be terminated by a stop
condition, which is a LOW to HIGH transition of SDA
when SCL is HIGH. The stop condition is also used to
place the device into the standby power mode after a
read sequence. A stop condition can only be issued
after the transmitting device has released the bus.
Acknowledge
Acknowledge is a software convention used to indicate
successful data transfer. The transmitting device,
either master or slave, will release the bus after trans-
mitting eight bits. During the ninth clock cycle the
receiver will pull the SDA line LOW to acknowledge
that it received the eight bits of data. Refer to Figure 3.
The X24165 will respond with an acknowledge after
recognition of a start condition and its slave address. If both
the device and a write operation have been selected,
the X24165 will respond with an acknowledge after the
receipt of each subsequent eight-bit word.
In the read mode the X24165 will transmit eight bits of
data, release the SDA line and monitor the line for an
acknowledge. If an acknowledge is detected and no stop
condition is generated by the master, the X24165 will
continue to transmit data. If an acknowledge is not
detected, the X24165 will terminate further data trans
-missions.
The master must then issue a stop condition to return the
X24165 to the standby power mode and place the device into
a known state.
Figure 3. Acknowledge Response From Receiver
SCL FROM
MASTER
1
DATA OUTPUT
FROM
TRANSMITTER
DATA
OUTPUT
FROM
RECEIVER
START
8
9
ACKNOWLEDGE
6551 ILL F06
4