X24165 Datasheet, PDF (11/17 Pages) Xicor Inc. – Advanced 2-Wire Serial E2PROM with Block Lock Protection

X24165
ABSOLUTE MAXIMUM RATINGS*
Temperature Under Bias
X24165 .......................................–65°C to +135°C
Storage Temperature ........................–65°C to +150°C
Voltage on any Pin with
Respect to V_SS .................................... –1V to +7V
D.C. Output Current ..............................................5mA
Lead Temperature (Soldering, 10 Seconds) ...... 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum”
Ratings” may cause permanent damage to the device. This is
a stress rating only and the functional operation of the device
at these or any other conditions above those indicated in
the operational sections of this specification is not implied.
Exposure to absolute maximum rating conditions for
extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Min.
Max.
Commercial
0°C
+70°C
Industrial
Military
–40°C
–55°C
+85°C
+125°C
6551 FRM T04
D.C. OPERATING CHARACTERISTICS
Supply Voltage
X24165
X24165-2.7
Limits
4.5V to 5.5V
2.7V to 5.5V
6551 FRM T05
Limits
Symbol
I_CC1
I_CC2
Parameter
V_CC Supply Current (Read)
V_CC Supply Current (Write)
I_SB1 ⁽¹⁾
V_CC Standby Current
Min.
I_SB2 ⁽¹⁾
V_CC Standby Current
I_LI
I_LO
V_lL ⁽²⁾
V_IH ⁽²⁾
V_OL
Input Leakage Current
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
Output LOW Voltage
–1
V_CC x 0.7
CAPACITANCE T_A = +25°C, f = 1MHz, V_CC = 5V
Max.
1
3
50
1
10
10
V_CC x 0.3
Units
Test Conditions
mA _{SCL = VCC X 0.1/VCC X 0.9 Levels @}
mA ^{100KHz, SDA = Open, All Other}
Inputs = V_SS or V_CC – 0.3V
∝A _{SCL = SDA = VCC, All Other}
Inputs = V_SS or V_CC – 0.3V,
V_CC = 5V ± 10%
∝A _{SCL = SDA = VCC, All Other}
Inputs = V_SS or V_CC – 0.3V,
V_CC = 2.7V
∝A _{VIN = VSS to VCC}
∝A _{VOUT = VSS to VCC}
V
V_CC + 0.5 V
0.4
V I_OL = 3mA, V_CC = 4.5V
6551 FRM T06.1
Symbol
C_I/O ⁽³⁾
C_IN ⁽³⁾
Parameter
Input/Output Capacitance (SDA)
Input Capacitance (S₁, S₂, SCL)
Max.
8
6
Units
pF
pF
Test Conditions
V_I/O = 0V
V_IN = 0V
Notes: (1)Must perform a stop command prior to measurement.
(2)VIL min. and VIH max. are for reference only and are not 100% tested. (3)This
parameter is periodically sampled and not 100% tested.
6551 FRM T07.1
11