X25320 Datasheet, PDF (3/15 Pages) Xicor Inc. – SPI Serial E2PROM With Block LockTM Protection

X25320
PRINCIPLES OF OPERATION
The X25320 is a 4K x 8 E²PROM designed to interface
directly with the synchronous serial peripheral interface
(SPI) of many popular microcontroller families.
The X25320 contains an 8-bit instruction register. It is
accessed via the SI input, with data being clocked in on
the rising SCK. CS must be LOW and the HOLD and WP
inputs must be HIGH during the entire operation. The
WP input is “Don’t Care” if WPEN is set “0”.
Table 1 contains a list of the instructions and their
opcodes. All instructions, addresses and data are trans-
ferred MSB first.
Data input is sampled on the first rising edge of SCK after
CS goes LOW. SCK is static, allowing the user to stop
the clock and then resume operations. If the clock line is
shared with other peripheral devices on the SPI bus, the
user can assert the HOLD input to place the X25320 into a
“PAUSE” condition. After releasing HOLD, the X25320
will resume operation from the point when HOLD was first
asserted.
Write Enable Latch
The X25320 contains a “write enable” latch. This latch
must be SET before a write operation will be completed
internally. The WREN instruction will set the latch and the
WRDI instruction will reset the latch. This latch is
automatically reset upon a power-up condition and after the
completion of a byte, page, or status register write
cycle.
Status Register
The RDSR instruction provides access to the status
register. The status register may be read at any time,
even during a write cycle. The status register is format- ted
as follows:
7 654 3
2
10
WPEN X X X BP1 BP0 WEL WIP
3063 PGM T02
WPEN, BP0 and BP1 are set by the WRSR instruction.
WEL and WIP are read-only and automatically set by
other operations.
The Write-In-Process (WIP) bit indicates whether the
X25320 is busy with a write operation. When set to a “1”,
a write is in progress, when set to a “0”, no write is in
progress. During a write, all other bits are set to “1”.
The Write Enable Latch (WEL) bit indicates the status of the
“write enable” latch. When set to a “1”, the latch is set,
when set to a “0”, the latch is reset.
The Block Protect (BP0 and BP1) bits are nonvolatile and
allow the user to select one of four levels of protec-
tion. The X25320 is divided into four 8192-bit segments.
One, two, or all four of the segments may be protected.
That is, the user may read the segments but will be
unable to alter (write) data within the selected segments.
The partitioning is controlled as illustrated below.
Status Register Bits
BP1
BP0
0
0
0
1
1
0
1
1
Array Addresses
Protected
None
$0C00–$0FFF
$0800–$0FFF
$0000–$0FFF
3063 PGM T03
Table 1. Instruction Set
Instruction Name
WREN
WRDI
RDSR
WRSR
Instruction Format*
0000 0110
0000 0100
0000 0101
0000 0001
Operation
Set the Write Enable Latch (Enable Write Operations)
Reset the Write Enable Latch (Disable Write Operations)
Read Status Register
Write Status Register
READ
0000 0011
Read Data from Memory Array beginning at selected
address
WRITE
0000 0010
Write Data to Memory Array beginning at Selected Address (1
to 32 Bytes)
*Instructions are shown MSB in leftmost position. Instructions are transferred MSB first.
3063 PGM T04
3