ICG2130 Datasheet, PDF (2/7 Pages) IC MICROSYSTEMS – DC-3000 MHz GENERAL PURPOSE AMPLIFIER

Pin #
1
2
3
4
5
6
Symbol
Gnd
RFin
Gnd
Gnd
Vcc/RFout
Gnd
Description
Ground connection. Keep traces physically short and immediately connect to ground
plane.
RF input pin. This pin is not externally DC blocked and thus requires an external
blocking capacitor suitable for the frequency of operation. The input impedance of this
pin is internally matched to 50 using resistive feedback.
Same as Pin 1
Same as Pin 1
RF out and bias pin. The input impedance of this pin is internally matched to 50 using
resistive feedback. Bias should be supplied to this pin externally. Please note that an
RF choke inductor is required but no external bias resistor is needed. A DC blocking
capacitor should be used for most applications since DC bias is present on this pin. The
supply should be well-bypassed.
Same as Pin 1
#
Symbol
VCC
TOP
TSTG
TSOL
Parameter
Positive Power Supply
Operating Temperature
Storage Temperature
Soldering Temperature
Value
+4.0
-40 to +85
-65 to +150
300
Unit
VDC
o_C
o_C
o_C
Note: Stress greater than those listed above may cause permanent
damage to the device. This is a stress rating only and functional
operation of the device at these or any other conditions above those
indicated in the operational sections of this specification is not implied.
Exposure to absolute maximum rating conditions for extended periods
may affect reliability.
Part
ICG2130
ICG2130-EVAL
Description
6L-SOT23, 3V Amplifier
Fully Assembled Evaluation Board
Parameter Value
Unit
VCC
+3.0
VDC
TOP
+25
o_C
Unless otherwise stated, measurements were done on the
evaluation board
$%& '()
*(+ &,* *, *
Appropriate precaution in handling,
packaging and testing must be
observed
Rev. 1.0
ICmic reserves the right to change the specifications without notice.
2
28/12/04
For more information please visit http://www.icmic.com