ICG2130 Datasheet, PDF (1/7 Pages) IC MICROSYSTEMS – DC-3000 MHz GENERAL PURPOSE AMPLIFIER

• Characterized for 100-3000MHz Operation
• +26 dBm Output IP3
• +17 dB Gain at 850 MHz
• +12 dB Gain at 2000 MHz
• Internally 50 matched input and output
• +3V Single Voltage Supply
• Low Current Consumption: 30mA
• IF or RF Buffer Amplifier
• Driver/Pre-Driver for CATV/SAT TV Amplifier
• VCO Buffer Driving Up/Down Converter
• General Rx/Tx Amplification
• LNB IF Path
• ISM Band Transceivers - WLAN - IEEE 802.11,
Bluetooth
• ISO/EPC Compliant UHF RFID Readers
The ICG series of Gain Blocks are general purpose gain
stages consisting of Broadband MMIC amplifiers in a
Darlington configuration. The amplifiers housed in a low-
cost surface mountable package provide a high output
intercept point, high gain and low noise figure and do not
require an external bias resistor.
The ICG2130 can be used for amplification in IF and RF
applications from 100 MHz to 3000 MHz. The amplifier
provides a gain of 17dB typically at 850 MHz and has
single ended input and output, internally matched to 50
Ohms. The device can be operated with a single +3V
supply.
The IC is available in industry standard 6L-SOT23
package.
Gnd 1
RFin ²
Gnd 3
Bias
ICG2130
6 _Gnd
5 _{Vcc / RFout}
4 Gnd
Gnd 1
Rfin ²
Gnd 3
6L-SOT23
ICG2130
!"
6 _Gnd
5 _{Vcc / RFout}
4 Gnd
IICCMGI2C130
Performance tests for ICmic products were performed internally by ICmic and measured using specific systems and/or components. Any difference in circuit implementation, test software, or test equipment
may affect actual performance. The information provided herein is believed to be reliable at the time of this printing. ICmic assumes no responsibility for the use of this information and/or the described
product(s). Prices and specifications are subject to change without notice. Copyright 2004 IC MICROSYSTEMS SDN. BHD. All worldwide rights reserved
Rev. 1.0
ICmic reserves the right to change the specifications without notice.
1
28/12/04
For more information please visit http://www.icmic.com