X24320 Datasheet, PDF (10/17 Pages) Xicor Inc. – 400KHz 2-Wire Serial E2PROM with Block Lock

X24320
reset, nor can RWEL and WEL be reset in one write
operation. RWEL can be reset by writing 00000010 to
FFFFh; but this is the same operation as in step 3
described below, and will result in programing BL0,
BL1, and WPEN.
Writing to the BL and WPEN Bits
A 3 step sequence is required to change the nonvola- tile
Block Lock Protect or Write Protect Enable bits:
1) Set WEL=1, Write 00000010 to address FFFFh
(Volatile Write Cycle.)
2) Set RWEL=1, Write 00000110 to address FFFFh
(Volatile Write Cycle.)
3) Set BL1, BL0, and/or WPEN bits, Write u00xy010 to
address FFFFh, where u=WPEN, x=BL1, and y=BL0.
(Nonvolatile Write Cycle.)
The three step sequence was created to make it diffi _-
cult to change the contents of the Write Protect
Register accidentally. If WEL was set to one by a
previous register write operation, the user may start at
step 2. RWEL is reset to zero in step 3 so that user is
required to perform steps 2 and 3 to make another
change. RWEL must be 0 in step 3. If the RWEL bit in the data
byte for step 3 is a one, then no changes are
made to the Write Protect Register and the device
remains at step 2.
The WP pin must be LOW or the WPEN bit must be LOW
before a nonvolatile register write operation is
initiated. Otherwise, the write operation will abort and the
device will go into standby mode after the master
issues the stop condition in step 3.
Step 3 is a nonvolatile write operation, requiring tWC to
complete (acknowledge polling may be used to reduce
this time requirement). It should be noted that step 3 MUST
end with a stop condition. If a start condition is
issued during or at the end of step 3 (instead of a stop
condition) the device will abort the nonvolatile register
write and remain at step 2. If the operation is aborted with a
start condition, the master must issue a stop to
put the device into standby mode.
ABSOLUTE MAXIMUM RATINGS*
Figure 11. Block Lock Protect Bits and Protected Addresses
BL1
BL0
0
0
0
1
1
0
1
1
Protected Addresses
None
C00h - FFFh
800h - FFFh
000h - FFFh
Figure 12. WP Pin and WPEN Bit Functionality
WP
WPEN
Memory Array Not
Lock Block Protected
Memory Array Block
Lock Protected
0
X
Writable
Protected
X
0
Writable
Protected
1
1
Writable
Protected
Array Location
No Protect
Upper 1/4
Upper 1/2
Full Array
7003 FRM T02
Block Lock Bits
Unprotected
Unprotected
Protected
WPEN
Bit
Unprotected
Unprotected
Protected
7003 FRM T03
10