X24320 Datasheet, PDF (1/17 Pages) Xicor Inc. – 400KHz 2-Wire Serial E2PROM with Block Lock

This X24320 device has been acquired by
IC MICROSYSTEMS from Xicor, Inc.
ICmic^TM
IC MICROSYSTEMS
32K
X24320
400KHz 2-Wire Serial E²PROM with Block Lock^TM
4K x 8 Bit
FEATURES
•Save Critical Data with Programmable
Block Lock Protection
—Block Lock (0, 1/4, 1/2, or all of E²PROM Array)
—Software Write Protection
•In—CPirrocguirtaPmrmogarbalme ^{Hmaarbdlwe aRrOe} MWrMitoedPerotect
•400KHz 2-Wire Serial Interface
—Schmitt Trigger Input Noise Suppression
—Output Slope Control for Ground Bounce
Noise Elimination
•Longer Battery Life With Lower Power
—Active Read Current Less Than 1mA
—Active Write Current Less Than 3mA
—Standby Current Less Than 1µA
•1.8V to 3.6V, 2.5V to 5.5V and 4.5V to 5.5V
Power Supply Versions
•32 Word Page Write Mode
—Minimizes Total Write Time Per Word
•Internally Organized 4K x 8
•Bidirectional Data Transfer Protocol
•Self-Timed Write Cycle
—Typical Write Cycle Time of 5ms
•High Reliability
—Endurance: 100,000 Cycles
—Data Retention: 100 Years
•8-Lead SOIC
•14-Lead TSSOP
•8-Lead PDIP
FUNCTIONAL DIAGRAM
DESCRIPTION
The X24320 is a CMOS Serial E²PROM, internally
organized 4K x 8. The device features a serial inter-
face and software protocol allowing operation on a
simple two wire bus. The bus operates at 400 KHz all
the way down to 1.8V.
Three device select inputs (S0–S2) allow up to eight
devices to share a common two wire bus.
A Write Protect Register at the highest address location,
FFFFh, provides three write protection features:
Software Write Protect, Block Lock Protect, and
Programmable Hardware Write Protect. The Software
Write Protect feature prevents any nonvolatile writes to the
device until the WEL bit in the Write Protect
Register is set. The Block Lock Protection feature gives
the user four array block protect options, set by
programming two bits in the Write Protect Register. The
Programmable Hardware Write Protect feature
allows the user to install the device with WP tied to
VCC, write to and Block Lock the desired portions of
the memory array in circuit, and then enable the In
Circuit Programmable ROM Mode by programming the
WPEN bit HIGH in the Write Protect Register. After this,
the Block Locked portions of the array, including
the Write Protect Register itself, are permanently
protected from being erased.
SERIAL E²PROM DATA
AND ADDRESS (SDA)
DATA REGISTER
Y DECODE LOGIC
SCL
S2
S1
S0
COMMAND
DECODE
AND
CONTROL
LOGIC
BLOCK LOCK AND
WRITE PROTECT
CONTROL LOGIC
PAGE
DECODE
LOGIC
DEVICE
SELECT
LOGIC
WRITE
PROTECT
REGISTER
SERIAL E²PROM
ARRAY
4K x 8
1K x 8
1K x 8
2K x 8
WP
©Xicor, 1995, 1996 Patents Pending
7035-1.2 4/25/97 T0/C2/D0 SH
WRITE VOLTAGE
CONTROL
7035 FM 01
Characteristics subject to change without notice
1