IC-DX_14 Datasheet, PDF (2/9 Pages) IC-Haus GmbH – UNIVERSAL DIGITAL SENSOR OUTPUT DRIVER

iC-DX
UNIVERSAL DIGITAL SENSOR OUTPUT DRIVER
Rev C1, Page 2/9
DESCRIPTION
The iC-DX is a monolithic switch capable of driving
ohmic, inductive and capacitive loads and features in-
tegrated reverse polarity protection. The supply volt-
age VB of the device can range from 8 to 30 V.
Output source/sink-current is at least 150 mA, with
saturation voltages of 2 V max.
a high-side (PNP) or low-side (NPN) driver which is
activated by a high logic level on input OE.
Output transitions are slew-rate limited to minimize
interference on lines. The output is current limited to
450 mA maximum and short circuit protected by shut-
ting down the device with excessive temperature.
With input OE on high level state, the output works
as a push-pull stage under control of pin IN. If pin IN
is set either to high or low level, the output acts as
A regulated 5 V supply which can be loaded up to
10 mA is available at pin VOUT.
PACKAGING INFORMATION DFN6 2x2
PIN CONFIGURATION
1
6
2
5
3
4
dra_dfn6-1_pack_3, 20:1
PIN FUNCTIONS
No. Name Function
1 VOUT Regulated +5 V Voltage
2 GND Ground
3 IN Input
4 OE Output Enabled
5 OUT Driver Output
6 VB Supply Voltage
The Thermal Pad is to be connected to a Ground Plane (GND) on the PCB.
Only pin 1 marking on top or bottom defines the package orientation (top label and coding is subject to
change).