H393P Datasheet, PDF (2/3 Pages) Hi-Sincerity Mocroelectronics – LOW POWER LOW OFFSET VOLTAGE COMPARATORS

HI-SINCERITY
MICROELECTRONICS CORP.
Spec. No. : Preliminary Data
Issued Date : 2001.05.01
Revised Date : 2001.06.22
Page No. : 2/3
Absolute Maximum Ratings (see Note)
Rating
Power Supply Voltage
Differential Input Voltage
Symbol
VCC
VID
Value
Unit
36
V
36
V
Common-Mode Input Voltage
Output Short Current to GND
VI
-5 to 36
V
-
Infinite*
-
Power Dissipation
Operating Temperature
Storage Temperature
PD
350 (Ta≤55°C)
mW
Ta
-20 to +75
°C
Tstg
-55 to +125
°C
*: This value is specified with respect to the short circuit from output to GND. However, short circuit from the output to VCC
cause device destruction.
Note: Permanent device damage may occur if the above Absolute Maximum Ratings are exceeded. Functional operation should
be restricted to the conditions as detailed in the operational sections of this data sheet. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
Recommended Operating Conditions
Rating
Power Supply Voltage
Operating Temperature
Output Sink Current
Symbol
VCC
Ta
Isink
Value
Unit
2 to 30
±1.0 to ±15
V
-20 to +75
°C
≤40
mA
Electrical Characteristics (Vcc=5V, Ta=25°C)
Parameter
Symbol
Conditions
Min
Value
Typ Max
Units
Input Offset Voltage
Vio Vo=VREF=1.4V
-
2
5
mV
Input Offset Current
Iio -
-
5
50 nA
Input Bias Current
Iin*1 -
- 25 250 nA
Common-Mode Input Voltage Vcm*2 -
0
- Vcc-1.5 V
Power Supply Current
Icc RL=∞
-
2
3
mA
Voltage Gain
Av RL=15kΩ, Vcc=15V
- 200
- V/mV
Response Time
-
RL=1kΩ
-
2
-
us
Output Sink Current
Output Saturation Voltage
Output Leakage Current
Isink Vin₍₊₎=0, Vin_(-)=1V, Vol≤1.5V
40
-
-
mA
Vol Vin₍₊₎=0, Vin_(-)=1V, Isink≤30mA - 0.2 0.4
V
Ileak Vin₍₊₎=1V, Vin_(-)=0, Vo=30V
-
-
1
uA
Notes:
*1: Iin is measued when Vi≥0 and direction of the input current flows from IC. When negative voltage is applied to input pin, the
pin is equivalently connected the GND through a 1kΩ of resistor.
When low voltage below than –5V is applied, please connect a resistor serially to input pin in order to prevent the high
current flow.
*2: Positive input voltage may exceed the power supply voltage. As long as the other voltage remains in the common-mode
input voltage range, the comparator will provide a proper output state.
When Vcc=5V, your are requested to use Vin below 25V.
H393P
HSMC Product Specification