HBCR-1610 Datasheet, PDF (4/10 Pages) Agilent(Hewlett-Packard) – Single Chip Bar Code Decode IC

Table 5. Summary of Features and Configurations – HBCR-1610 Series
Feature
Bar Code
Symbology
Interleaved 2 of 5
Label Length
Check Character
Verification
Check Character
Transmission
Extended Code 39
Enable
UPC/EAN
Decoding Options
Codabar Start/
Stop Transmission
Baud Rates
Parity
Stop Bits
XON/XOFF Pacing†
Transmitted
Character Delay
Enable
Trailer Selection
Single Read Mode
Code ID Character
Enable
Good Read Beep
Tone Selection
LED Control
Function or Value
When a symbology is enabled, bar
codes of that type can be read,
assuming other decoding options are
satisfied.
Length variable from 4 to 32, or
specific lengths from 2 to 32, or 6
or 14 only
For Code 39
For Interleaved 2 of 5
For Code 128†
For UPC/EAN†
For Code 39 and Interleaved 2 of 5
For UPC/EAN
For Code 128†
Converts paired Code 39 data
characters to Full ASCII characters
UPC vs. UPC/EAN
UPC E expansion to UPC A
UPC E Version 1 autodiscrimination
UPC/EAN supplemental digits
UPC/EAN check digit
UPC/EAN output format
Transmits or suppresses Codabar
start/stop characters
1200, 2400, 4800, 9600
0s, 1s, even, odd
1 or 2
Controls data flow on either port
Controls 10 millisecond intercharacter
delay on the serial port
String of characters appended
to the decoded message (4 maximum)
Controls when labels can be read
Controls the transmission of the Code
ID characters before decoded data
Controls the tone sounded when
a bar code label is read
Controls LED function: flash or
turn off after a label is read
Default Setting
Serial Mode
Parallel Mode
Depends on pins:
C39, I25, UPC
CDB and C28.
All codes enabled
Variable, 4-32
Variable, 4-32
Depends on pin C3C
Depends on pin I2C
Enabled
Enabled
Depends on pin CST
Enabled
Enabled
Depends on pin EX3
Depends on pin C3C
Depends on pin I2C
Enabled
Enabled
Depends on pin CST
Enabled
Enabled
Depends on pin EX3
UPC/EAN
Depends on pin UEE
Depends on pin UE1
Depends on pins US2
and US5
Transmitted
Standard
Depends on pin CSS
UPC/EAN
Depends on pin UEE
Depends on pin UE1
Disabled
Transmitted
Standard
Depends on pin CSS
Depends on pins BR0
and BR1
Depends on pins PT0
and PT1
Depends on pin STB
Enabled
Depends on pin ICD
–
0s
–
Enabled
–
CR_, CR LF_, HT_{, or none}
Depends on pins TR0
and TR1
Disabled
Disabled
C_R
Disabled
Disabled
High or low pitch
Depends on pin GRB
Auto Flash Mode
High or low pitch
Depends on pin GRB
Auto Flash Mode
†Not configurable.
4-40