HCPL-3000 Datasheet, PDF (3/9 Pages) Agilent(Hewlett-Packard) – Power Bipolar Transistor Base Drive Optocoupler

Insulation and Safety Related Specifications
Parameter
Symbol Value Units
Conditions
Min. External Air Gap
(External Clearance)
L(IO1) 6.0 mm Shortest distance measured through air, between
two conductive leads, input to output
Min. External Tracking L(IO2) 6.0 mm Shortest distance path measured along outside surface
Path (External Creepage)
of optocoupler body between the input and output leads
Min. Internal Plastic
Gap (Internal Clearance)
0.15 mm Through insulation distance conductor to conductor
inside the optocoupler cavity
Absolute Maximum Ratings
Parameter
Storage Temperature
Operating Temperature
Input Continuous Current
Reverse Voltage
Supply Voltage
Output 1 Continuous Current
Peak Current
Voltage
Output 2 Continuous Current
Peak Current
Output Power Dissipation
Total Power Dissipation
Lead Solder Temperature
Symbol
T_S
T_A
I_F
V_R
V_CC
I_O1
V_O1
I_O2
P_O
P_T
Min. Max. Unit
Conditions
Fig. Note
-55 125
°C
-20 80
°C
25
mA
9
1
6
V T_A = 25°C
18
V
0.5
A
10,11 1
1.0
A Pulse Width < 5 µs,
1
Duty cycle = 1%
18
V
0.6
A
10,11,12 1
2.0
A Pulse Width < 5 µs, 12
1
Duty cycle = 1%
500 mW
10
1
550 mW
11
1
260°C for 10 s, 1.0 mm below seating plane
Recommended Operating Conditions
Parameter
Power Supply Voltage
Input Current (ON)
Input Current (OFF)
Operating Temperature
Symbol
V_CC
I_F(ON)
I_F(OFF)
T_A
Min.
5.4
8*
-
-20
*The initial switching threshold is 5 mA or less.
Max.
13
20
0.2
80
Units
V
mA
mA
°C
Recommended Protection
for Output Transistors
During switching transitions, the
output transistors Q1 and Q2 of
the HCPL-3000 can conduct large
amounts of current. Figure 1
describes a recommended circuit
design showing current limiting
resistors R₁ and R₂ which are
necessary in order to prevent
damage to the output transistors
Q1 and Q2 (see Note 7). A bypass
capacitor C₁ is also recommended
to reduce power supply noise.
1-331