HPMX-2006 Datasheet, PDF (2/8 Pages) Agilent(Hewlett-Packard) – 0.8 - 2.5 GHz Upconverter/Amplifier

The amplifier features a single-
ended 50 Ω match on the input
port. The open collector output is
easily matched with a simple
2␣ element network, providing
flexible use and good power
added efficiency. The amplifier
can be disabled to allow use of the
mixer alone, reducing the current
draw to around 15 mA. The entire
IC can be put into a standby mode
reducing current consumption to
under 40 µA from a 3V source.
The SSOP-16 package insures that
the IC occupies a minimal amount
of printed circuit board space.
The HPMX-2006 is manufactured
using Hewlett-Packard’s 30 GHz
ISOSAT-II process which com-
bines stepper lithography, self
alignment, ion implantation
techniques and gold metalization
to produce state-of-the-art RFICs.
HPMX-2006 Absolute Maximum Ratings^[1]
Mixer
Amplifier
Symbol
Parameter
Units Min.
V_CC
Supply Voltage
V
-0.2
P_diss Power Dissipation^[2,3]
mW
Single-Ended Input Mixer LO Voltage
V
Single-Ended Input Mixer IF Voltage
V
Amplifier Input RF Power
dBm
T_j
T_STG
Junction Temperature
Storage Temperature
°C
-40
°C
-40
Notes:
1. Operation of this device in excess of any of these parameters may cause
permanent damage.
2. T_CASE = 25°C
3. Derate at 7 mW/°C for T_CASE >82°C.
Recommended operating range of Vcc = 2.7 to 5.5 V, Ta = -40 to + 85°C
Max.
8
174
V_C + 0.2
V_C + 0.2
Min.
-0.2
+150
-40
+150
-40
Max.
8
274
+5
+150
+150
Thermal Resistance^[2]:
θ_jc = 150°C/W
Standard Test Conditions
Unless otherwise stated, all test data was taken on packaged parts under the following conditions:
Vcc = +3.0 VDC, Zout = 50 Ω, ambient temperature Ta = 25°C
LO input: 1750 MHz, -3 dBm, single-ended
IF input: 150 MHz, 300 mVp-p, single-ended, terminated in a 50 Ω pull-up resistor (R1R2 in Figure 11)
Zout mixer = Zin amp = 50 Ω, Zout amp per Figure 11 ( (L=2.8 nH, C=2.2 pF)
See Figure 11 for test set-up schematic diagram.
HPMX-2006 Guaranteed Electrical Specifications
Standard test conditions apply unless otherwise noted.
Symbol
Parameters and Test Conditions
I_C mix
I_C amp
I_C mix
I_C amp
P_out
P_out
Sleep Mode Current, Mixer
Sleep Mode Current, Amplifier
Mixer Transmit Current
Amplifier Transmit Current
SSB Output Power, Mixer Only
Output Power, Amplifier Only (-9.5 dBm in)
Units
µA
µA
mA
mA
dBm
dBm
Min.
-11
+2.5
Typ.
15
23
-9
+3.8
Max.
20
20
18
28
7-67