IL2418 Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – Telephone Tone Ringer with Bridge Diode

TECHNICAL DATA
Telephone Tone Ringer with
Bridge Diode
IL2418
The IL2418 is a monolithic integrated circuit telephone tone ringer with
bridge diode, when coupled with an appropriate transducer, it replaces the
electro-mechanical bell. The device is designed for use with either a piezo
transducer or an inexpensive transformer coupled speaker to produce a
pleasing tone composed of a high frequency (f_R) alternating with a low
frequency (f_L) resulting in a warble frequency. The supply voltage is
obtained from the AC ring signal and the circuit is designed so that noise
on the line or variation of the ringing signal can not affect correct
operation of the device.
 On chip high voltage full wave diode bridge rectifier
 Low current consumption, in order to allow the parallel operation of
the 4 devices
 Low external component count
 Tone and switching frequencies adjustable by external components
 High noise immunity due to built-in voltage-current hysteresis
 Activation voltage adjustable
 Internal zener diodes to protect against over voltages
 Ringer impedance adjustable with external components
ORDERING INFORMATION
Device
Operating
Temperature Range
IL2418N
IL2418D
IL2418DT
TA = -40 to 70 C
Package
DIP8
SOP8
SOP8
Packing
Tube
Tube
Tape & Reel
BLOCK DIAGRAM
IL2418N Plastic DIP
IL2418D/DT SOIC
PIN ASSIGNMENT
2011, March, Rev. 01