BC66F840 Datasheet, PDF (58/242 Pages) Holtek Semiconductor Inc – 2.4GHz Flash RF TX/RX MCU

BC66F840/BC66F850/BC66F860
2.4GHz Flash RF TX/RX MCU
S LO W M ode
C K S 2~C K S 0¹000B ,001B as H LC LK =0
orH LC LK =1
N O R M A L M ode
W D T a n d L V D a r e a ll o ff
ID L E N = 0
H A L T in s tr u c tio n is e x e c u te d
S LE E P 0 M ode
W D T o r L V D is o n
ID L E N = 0
H A L T in s tr u c tio n is e x e c u te d
S LE E P 1 M ode
ID L E N = 1 , F S Y S O N = 0
H A L T in s tr u c tio n is e x e c u te d
ID L E 0 M o d e
ID L E N = 1 , F S Y S O N = 1
H A L T in s tr u c tio n is e x e c u te d
ID L E 1 M o d e
Entering the SLEEP0 Mode
There is only one way for the devices to enter the SLEEP0 Mode and that is to execute the HALT
instruction in the application program with the IDLEN bit in SMOD register equal to 0 and the
WDT and LVD both off. When this instruction is executed under the conditions described above, the
following will occur:
• The system clock, WDT clock and Time Base clock will be stopped and the application program
will stop at the HALT instruction.
• The Data Memory contents and registers will maintain their present condition.
• The WDT will be cleared and stopped.
• The I/O ports will maintain their present conditions.
• In the status register, the Power Down flag, PDF, will be set and the Watchdog time-out flag, TO,
will be cleared.
Rev. 1.40
58
May 24, 2017