HT45F0084 Datasheet, PDF (33/160 Pages) Holtek Semiconductor Inc – Cord-free Vacuum Cleaner ASSP Flash MCU

HT45F0084
Cord-free Vacuum Cleaner ASSP Flash MCU
Programming Considerations
Care must be taken that data is not inadvertently written to the EEPROM. Protection can be
Periodic by ensuring that the Write Enable bit is normally cleared to zero when not writing. Also
the Bank Pointer could be normally cleared to zero as this would inhibit access to Bank 1 where
the EEPROM control register exist. Although certainly not necessary, consideration might be given
in the application program to the checking of the validity of new write data by a simple read back
process. When writing data the WR bit must be set high immediately after the WREN bit has been
set high, to ensure the write cycle executes correctly. The global interrupt bit EMI should also be
cleared before a write cycle is executed and then re-enabled after the write cycle starts. Note that
the device should not enter the IDLE or SLEEP mode until the EEPROM read or write operation is
totally complete. Otherwise, the EEPROM read or write operation will fail.
Programming Examples
• Reading data from the EEPROM – polling method
MOV A, EEPROM_ADRES ; user defined address
MOV EEA, A
MOV A, 040H
; setup memory pointer MP1
MOV MP1, A ; MP1 points to EEC register
MOV A, 01H ; setup Bank Pointer
MOV BP, A
SET IAR1.1 ; set RDEN bit, enable read operations
SET IAR1.0 ; start Read Cycle - set RD bit
BACK:
SZ IAR1.0 ; check for read cycle end
JMP BACK
CLR IAR1 ; disable EEPROM read/write
CLR BP
MOV A, EED ; move read data to register
MOV READ_DATA, A
• Writing Data to the EEPROM – polling method
CLR EMI
MOV A, EEPROM_ADRES ; user defined address
MOV EEA, A
MOV A, EEPROM_DATA ; user defined data
MOV EED, A
MOV A, 040H
; setup memory pointer MP1
MOV MP1, A ; MP1 points to EEC register
MOV A, 01H ; setup Bank Pointer
MOV BP, A
CLR EMI
SET IAR1.3 ; set WREN bit, enable write operations
SET IAR1.2 ; start Write Cycle - set WR bit
SET EMI
BACK:
SZ IAR1.2 ; check for write cycle end
JMP BACK
CLR IAR1 ; disable EEPROM read/write
CLR BP
Rev. 1.00
33
March 17, 2017