BS83B08A-3 Datasheet, PDF (32/119 Pages) Holtek Semiconductor Inc – 8-Bit Touch Key Flash MCU

BS83B08A-3/BS83B12A-3/BS83B16A-3
BS83B08A-4/BS83B12A-4/BS83B16A-4
8-Bit Touch Key Flash MCU
Reading Data from the EEPROM
To read data from the EEPROM, the read enable bit, RDEN, in the EEC register must first be set
high to enable the read function. The EEPROM address of the data to be read must then be placed
in the EEA register. If the RD bit in the EEC register is now set high, a read cycle will be initiated.
Setting the RD bit high will not initiate a read operation if the RDEN bit has not been set. When
the read cycle terminates, the RD bit will be automatically cleared to zero, after which the data can
be read from the EED register. The data will remain in the EED register until another read or write
operation is executed. The application program can poll the RD bit to determine when the data is
valid for reading.
Writing Data to the EEPROM
To write data to the EEPROM, the write enable bit, WREN, in the EEC register must first be set
high to enable the write function. The EEPROM address of the data to be written must then be
placed in the EEA register and the data placed in the EED register. If the WR bit in the EEC register
is now set high, an internal write cycle will then be initiated. Setting the WR bit high will not initiate
a write cycle if the WREN bit has not been set. As the EEPROM write cycle is controlled using an
internal timer whose operation is asynchronous to microcontroller system clock, a certain time will
elapse before the data will have been written into the EEPROM. Detecting when the write cycle
has finished can be implemented either by polling the WR bit in the EEC register or by using the
EEPROM interrupt. When the write cycle terminates, the WR bit will be automatically cleared to
zero by the microcontroller, informing the user that the data has been written to the EEPROM. The
application program can therefore poll the WR bit to determine when the write cycle has ended.
Write Protection
Protection against inadvertent write operation is provided in several ways. After the device is
powered-on the Write Enable bit in the control register will be cleared preventing any write
operations. Also at power-on the Bank Pointer, BP, will be reset to zero, which means that Data
Memory Bank 0 will be selected. As the EEPROM control register is located in Bank 1, this adds a
further measure of protection against spurious write operations. During normal program operation,
ensuring that the Write Enable bit in the control register is cleared will safeguard against incorrect
write operations.
EEPROM Interrupt
The EEPROM write interrupt is generated when an EEPROM write cycle has ended. The EEPROM
interrupt must first be enabled by setting the DEE bit in the relevant interrupt register. When an
EEPROM write cycle ends, the DEF request flag will be set. If the global, EEPROM is enabled and
the stack is not full, a jump to the associated Interrupt vector will take place. When the interrupt is
serviced, the EEPROM interrupt flag will automatically reset. More details can be obtained in the
Interrupt section.
Rev. 1.00
32
May 02, 2013