HT69F340 Datasheet, PDF (229/235 Pages) Holtek Semiconductor Inc – TinyPowerTM I/O Flash MCU with LCD & EEPROM

HT69F340/HT69F350/HT69F360
TinyPower^TM I/O Flash MCU with LCD & EEPROM
LSNZ [m]
Description
Operation
Affected flag(s)
LSUB A,[m]
Description
Operation
Affected flag(s)
LSUBM A,[m]
Description
Operation
Affected flag(s)
LSWAP [m]
Description
Operation
Affected flag(s)
LSWAPA [m]
Description
Operation
Affected flag(s)
LSZ [m]
Description
Operation
Affected flag(s)
LSZA [m]
Description
Operation
Affected flag(s)
Skip if Data Memory is not 0
Ifthe content of the specified Data Memory is not 0, the following instruction is skipped. As
this requires the insertion of a dummy instruction while the next instruction is fetched, it is a
two cycle instruction. If the result is 0 the program proceeds with the following instruction.
Skip if [m] ≠ 0
None
Subtract Data Memory from ACC
The specified Data Memory is subtracted from the contents of the Accumulator. The result is
stored in the Accumulator. Note that if the result of subtraction is negative, the C flag will be
cleared to 0, otherwise if the result is positive or zero, the C flag will be set to 1.
ACC ← ACC − [m]
OV, Z, AC, C, SC, CZ
Subtract Data Memory from ACC with result in Data Memory
The specified Data Memory is subtracted from the contents of the Accumulator. The result is
stored in the Data Memory. Note that if the result of subtraction is negative, the C flag will be
cleared to 0, otherwise if the result is positive or zero, the C flag will be set to 1.
[m] ← ACC − [m]
OV, Z, AC, C, SC, CZ
Swap nibbles of Data Memory
The low-order and high-order nibbles of the specified Data Memory are interchanged.
[m].3~[m].0 ↔ [m].7~[m].4
None
Swap nibbles of Data Memory with result in ACC
The low-order and high-order nibbles of the specified Data Memory are interchanged. The
result is stored in the Accumulator. The contents of the Data Memory remain unchanged.
ACC.3~ACC.0 ← [m].7~[m].4
ACC.7~ACC.4 ← [m].3~[m].0
None
Skip if Data Memory is 0
If the contents of the specified Data Memory is 0, the following instruction is skipped. As this
requires the insertion of a dummy instruction while the next instruction is fetched, it is a two
cycle instruction. If the result is not 0 the program proceeds with the following instruction.
Skip if [m]=0
None
Skip if Data Memory is 0 with data movement to ACC
The contents of the specified Data Memory are copied to the Accumulator. If the value is zero,
the following instruction is skipped. As this requires the insertion of a dummy instruction
while the next instruction is fetched, it is a two cycle instruction. If the result is not 0 the
program proceeds with the following instruction.
ACC ← [m]
Skip if [m]=0
None
Rev. 1.30
229
November 18, 2016