HMC713MS8_09 Datasheet, PDF (9/10 Pages) Hittite Microwave Corporation – 54 dB, LOGARITHMIC DETECTOR / CONTROLLER, 100 - 2700 MHz

HMC713MS8 / 713MS8E
v05.1009
54 dB, LOGARITHMIC
DETECTOR / CONTROLLER, 100 - 2700 MHz
Application & Evaluation PCB Schematic
12
Notes
Note 1: The HMC713MS8(E) evaluation board is pre-assembled for single-ended input, and detector/RSSI mode.
Note 2: For detector mode, connect high impedance volt meter to the OUT / OUTN port.
Note 3: For controller mode, remove R6 & C3 and install 1k Ω resistor (R4) and 100pF capacitor (C2), then make appropriate
connection to OUT and VSET. In controller mode, the OUT / OUTN output can be used to drive a variable gain amplifier,
or a variable attenuator, either directly or through a buffer or microcontroller. VSET should be connected to an external
supply, typically between +0.2 and +1.2V.
Note 4: An external capacitance C1 can be connected to CLPF port for additional filtering of OUT and OUTN outputs..
Power-Up Timing Diagram
12 - 124
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
20 Alpha Road, Chelmsford, MA 01824 Phone: [phone] Fax: [phone]
Order On-line at www.hittite.com