HMC667LP2 Datasheet, PDF (8/8 Pages) Hittite Microwave Corporation – GaAs PHEMT MMIC LOW NOISE AMPLIFIER, 2.3 - 2.7 GHz

v02.1110
Evaluation PCB
HMC667LP2 / 667LP2E
GaAs PHEMT MMIC LOW NOISE
AMPLIFIER, 2.3 - 2.7 GHz
7
List of Materials for Evaluation PCB ^[1]
Item
Description
J1 - J2
PCB Mount SMA Connector
J3 - J4
DC Pin
C1
2.7 pF Capacitor, 0402 Pkg.
C2
1000 pF Capacitor, 0402 Pkg.
C3
10 nF Capacitor, 0603 Pkg.
C4
2.2 μF Capacitor, CASE-A Tantalum
L1
2 nH Inductor, 0402 Pkg.
U1
PCB ^[2]
HMC667LP2(E) Amplifier
117163 Evaluation PCB
[1] When requesting an evaluation board, please reference the
appropriate evaluation PCB number listed in the table
“Components for Selected Band” on previous page
[2] Circuit Board Material: Rogers 4350
The circuit board used in this application should use
RF circuit design techniques. Signal lines should
have 50 Ohm impedance while the package ground
leads and exposed paddle should be connected
directly to the ground plane similar to that shown.
A sufficient number of via holes should be used to
connect the top and bottom ground planes. The
evaluation board should be mounted to an appro-
priate heat sink. The evaluation circuit board shown
is available from Hittite upon request.
For price, delivery and to place orders: Hittite Microwave Corporation, 20 Alpha Road, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
Application Support: Phone: [phone] or [e-mail]
7-8