HMC600LP4_09 Datasheet, PDF (6/8 Pages) Hittite Microwave Corporation – 75 dB LOGARITHMIC DETECTOR / CONTROLLER 50 - 4000 MHz

HMC600LP4 / 600LP4E
v02.0909
75 dB LOGARITHMIC
DETECTOR / CONTROLLER 50 - 4000 MHz
Package Information
Part Number
Package Body Material
HMC600LP4
Low Stress Injection Molded Plastic
Lead Finish
Sn/Pb Solder
HMC600LP4E RoHS-compliant Low Stress Injection Molded Plastic 100% matte Sn
[1] Max peak reflow temperature of 235 °C
[2] Max peak reflow temperature of 260 °C
[3] 4-Digit lot number XXXX
MSL Rating
MSL1 ^[1]
MSL1 ^[2]
Package Marking ^[3]
H600
XXXX
H600
XXXX
Pin Descriptions
Pin Number
Function
1, 6, 7-13,
15, 18-24
N/C
Description
These pins are not connected internally; however,
this product is specified with these pins connected
to RF/DC ground.
Interface Schematic
12
2, 6
Vcc1, Vcc2
Bias supply. Connect supply voltage to both pins.
3, 4
INP, INN
RF Input pins. Connect RF to INP, and AC couple
INN to ground for single-ended operation.
Connect to 0V for normal operation. Applying voltage
>0.8 x Vcc will initiate a power saving shutdown mode.
14
PWD
To ensure proper start-up apply the power-up sequence
shown in the “Power-Up Timing Diagram” attached to the
application circuit.
16
17
Package
Base
VSET
LOGOUT
VSET input in controller mode. Short this
pin to LOGOUT for detector mode.
Logarithmic output that converts the input power
to a DC level in detector mode. Short this pin to
VSET for detector mode.
GND
Exposed paddle must be connected to RF and DC ground.
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
20 Alpha Road, Chelmsford, MA 01824 Phone: [phone] Fax: [phone]
Order On-line at www.hittite.com
12 - 7