HMC594LC3B_10 Datasheet, PDF (6/6 Pages) Hittite Microwave Corporation – GaAs PHEMT MMIC LOW NOISE AMPLIFIER, 2 - 4 GHz

Evaluation PCB
v02.0210
HMC594LC3B
GaAs PHEMT MMIC LOW NOISE
AMPLIFIER, 2 - 4 GHz
7
List of Materials for Evaluation PCB 109712 ^[1]
Item
Description
J1 - J2
SRI SMA Connector
J3 - J6
DC Pin
C1 - C2
100 pF Capacitor, 0402 Pkg.
C3 - C4
1000 pF Capacitor, 0603 Pkg.
C5 - C6
2.2 μF Capacitor, Tantalum
U1
HMC594LC3B Amplifier
PCB ^[2]
109710 Evaluation PCB, 10 mils
[1] Reference this number when ordering complete evaluation PCB
[2] Circuit Board Material: Rogers 4350
The circuit board used in the application should use
RF circuit design techniques. Signal lines should
have 50 Ohm impedance while the package ground
leads and exposed paddle should be connected
directly to the ground plane similar to that shown.
A sufficient number of via holes should be used to
connect the top and bottom ground planes. The
evaluation board should be mounted to an appro-
priate heat sink. The evaluation circuit board shown
is available from Hittite upon request.
For price, delivery and to place orders: Hittite Microwave Corporation, 20 Alpha Road, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
Application Support: Phone: [phone] or [e-mail]
7 - 201