HMC6000LP711E Datasheet, PDF (10/18 Pages) Hittite Microwave Corporation – Multi-Gbps Data Communications

HMC6000LP711E
v00.1112
Millimeterwave Transmitter
57 - 64 GHz
Antenna-in-Package Location and Polarization
The antenna is located inside the package with geometric center and linear polarization angle as shown. The
geometric center can be used as the antenna pattern phase center provided there is sufficient unobstructed ground
plane extension around the chip. Measured antenna pattern phase centers will vary with frequecy and are dependent
on finite ground plane effects, and coupling to nearby components.
Evaluation PCB Daughtercard
The circuit board used in the application should use RF circuit design techniques. Signal lines should have 50 Ohm
impedance while the package ground leads and exposed paddle should be connected directly to the ground plane
similar to that shown. A sufficient number of via holes should be used to connect the top and bottom ground planes.
The evaluation circuit board shown is part of an evaluation kit available from Hittite.
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
10
Application Support: Phone: [phone] or [e-mail]