FX8C-60P-SV Datasheet, PDF (9/11 Pages) Hirose Electric – 0.6mm Pitch Stacking Height 3mm to 16mm Connector

BConnector Precautions
1. Tolerance Clearance on Mating Side
The effective contact length of the product is set to 2.0mm. Please use the product
so as to set to less than 12mm the clearance between the header and the receptacle in the mating process..
2. Fixation Between Mounting Boards
If this product is fixed only by mating force, Please consider the fixing method so as not to apply loads such as vibration, shock and so
on.
3. Stacking General Tolerance in Mating
Stack
Amm
A
+0.3
–0.2
mm
Note: Please Note that the above tolerance of the stacking height doesn't include the solder paste thickness.
4. Handling Two-piece Connection Product
Both joint bar edges of the two-piece connection product are fixed by joints, while the mating process can't be performed in that state.
Before the mating process, please remove the joint bars as if pull it up. (Don't remove the joint bars before mounting on the board. )
Before removing joint bar
After removing joint bar
5. Mounting Temperature Profile (Reference)
Applicable Conditions
Reflow system
Solder
Test board
Metal mask thickness
:IR reflow
:Paste type 63 Sn/37 Pb
(Flux content 11 wt%)
:Glass epoxy 161mm x 100mm x 1.6 mm
:0.15 mm
Recommended temperature profile.
The temperature may be slightly changed according to the solder
paste type and amount.
6. Cautions
This product is made as the thin formed product in order to be miniaturized.
A244