FX5-20P-SH Datasheet, PDF (7/7 Pages) Hirose Electric – 1mm Pitch Connector for Vertical Connection

BConnector Precautions
1. Tolerance Clearance on Mating Side
1
The effective connection clearance of the product is 1.6mm. Please use the
product so as to specify within 1mm the clearance between the header and
the receptacle in the connection process.
2. Header Connector Height
The SMT connector height doesn't include the solder paste thickness.
Thus, please consider that the stacking height will slightly increase after the
mounting process.
Mating Height: Low profile
FX5-πP-SH
Mating Height: High profile
FX5-*P-SH3
PCB
PCB
3. Screw Fastening Torque (SMT Type)
When the screw is fastened, please use the M2 screw. The recommended
fastening torque is 0.15(N.m) max.
Nut (M2)
Plain sheet (t = 0.3)
4. Prefixed Process to Board (Through hole Type)
If the prefixed process is required for board mounting, please use the
prefixed pin type. (Applicable Thickness t = 1.6±0.1)
Note:
When the connector is mounted on the board, the dip post is guided into the
board through-hole in order to prevent the dip post damage, and then insert
the board in parallel to the connector so as to push in the prefixed pin.
Screw (M2)
Board (t = 1.6)
Spring sheet (t = 0.5)
Prefixed pin
PCB
5. Plug and Play
When the connector is inserted or extracted in the active line state, please
contact HRS company.
6. Others
q It is noted that the forced excessive insertion/extraction will result in damage.
q Avoid holding the board with the connector only, and fix the board by any other
means except for the connector.
q The color phase of this product may be slightly different from that of the forming
product according to the manufacturing lot, but the difference doesn't affect the
performance.
Dip post
A212