W-FL Datasheet, PDF (2/6 Pages) Hirose Electric – Ultra Small Surface Mount Coaxial Connectors – 1.4mm Mated Height

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
sProduct Specifications
Ratings
Nominal characteristic
impedance
Frequency range
50 ohms
DC to 6GHz
Operating temperature range
Operating humidity
-40ç to +90ç
(Relative humidity 90% max.)
-40ç to +70ç
(Relative humidity 90% max.)
sMaterials and Finishes
Item
Specification
1. Contact resistance
Center: 20m ohms max. Outside: 10m ohms max.
2. Insulation resistance 500M ohms min., 100V DC
3. Withstanding voltage 200V AC / 1 minute
4. V.S.W.R.(Note)
1.3 max. (Up to 3GHz)
1.35 max. (3 to 6GHz)
Note:V.S.W.R. Measurement System
Note:Measured as shown on the block diagram below.
Note:Test connection and measurement setup.
Network Analyzer
Test Set
Test Port
Test Port Cable
D.U.T Termination
Note1:Cable type connector measurements.
With SMA conversion adapters mated with W.FL plug
at each end of the 100cm long ultra-fine coaxial cable.
Note2:Board type connector measurements.
Mounted on a 50 ohms glass epoxy board.
Measurements were conducted with SMA conversion
adapters attached.
sMaterial/Finishes
Part
Plug
Receptacle
Component
Shell
Insulator
Socket center contact
Shell
Insulator
Pin center contact
sPlug
Material
Phosphor bronze
PBT
Phosphor bronze
Phosphor bronze
LCP
Brass
Finish/Remarks
Silver plated
Black, UL94V-0
Gold plated
Silver plated
Black, UL94V-0
Gold plated
2.85
Plugs can be ordered only terminated to the cable.
2