MMCX-LP-FHSB Datasheet, PDF (2/8 Pages) Hirose Electric – Ultra Miniature Snap-on Coaxial Connector (PC Card Type 2 Mountable)

sProduct Specifications
Rating
Nominal characteristic impedance
Rated frequency
50 ohms
DC-6GHz
Operating Temperature Range
Operating Relative Humidity
-55ç to +85ç
90% max.
Item
Specification
01. Insulation Resistance 500M ohms min.
02. Withstanding Voltage Neither short nor breakdown
03. Contact Resistance ^{10m ohms max. (center),}
05m ohms max. (outer)
04. Female Contact Retention 0.2N to 2N
05. Insertion and withdrawal Insertion force: 15N max.
force (plug)
withdrawal force: 6 to 15N
06. Voltage standing
wave ratio
1.2 max.
1.2 max. (MMCX-LR-SMT only)
1.4 max. (MMCX-LR-SMT only)
07. Vibration
No electrical discontinuity of 1µs or more
No damage, cracks, or parts looseness.
08. Shock
No electrical discontinuity of 1µs or more
No damage, cracks, or parts looseness.
09. Humidity
No damage, cracks, or parts looseness.
Insulation resistance: 10M ohms min(High temperature)
Insulation resistance: 500M ohms min(Dry)
10. Temperature Cycle
Contact resistance: 20m ohms max. (center)
10m ohms max. (outer)
No damage, cracks, or parts looseness.
11. Operating Life
Contact resistance: 20m ohms max. (center)
10m ohms max. (outer)
12. Resistance to Corrosion No marked corrosion
500V DC
500V AC / 1 minute
Condition
100mA (DC or 1000Hz)
Measured with the Ø0.37 pin gauge.
Measured with an appropriate connector.
DC to 6GHz
DC to 4GHz
4GHz to 6GHz
Measured at 0.45GHz to 6GHz
Frequency: 10 to 500 Hz, single amplitude of 0.75 mm or
acceleration of 98 m/s²(peak), 2 hours in each of the 3 directions.
Acceleration of 735 m/s², 6 ms duration, sine half-wave
waveform, 3 cycles in each of the 3 axis
96 hours at temperature of 40ç and humidity of 90% to 95%
Temperature of: -55ç ➝+20 to 35ç ➝+85ç ➝+20 to 35ç
Time: 30 minutes ➝5 minutes max. ➝30 minutes ➝5 minutes min.
5 cycles
500 cycles
Exposed to density 5% salt water for 48 hours
*Voltage standing wave ratio (V.S.W.R.) measuring system.
The above voltage standing wave ratio (V.S.W.R.) standard value is measured in the measuring system as shown below.
Network Analyzer
Test Set
Test Port
Test Post Cable
D.U.T Termination
NOTE 1 : The cable connector is measured with double ended 15cm cable
assembly.
NOTE 2 : The PCB connector is mounted on the 50 ohms printed circuit
board, to which Hirose's adaptor is connected.
sMaterial
Parts
Body
Male center contact
Female center contact
Male/female in-line contact
Insulator
Fixing ring
Crimp sleeve
Cover
Material
Brass
Stainless steel (conversion adaptor)
Phosphor bronze
Beryllium bronze
Beryllium copper (conversion adaptor)
PTFE
Beryllium copper (plug)
Copper
Brass (plug)
Finish
Gold plating
Gold plating
Gold plating
Gold plating
––
Gold plating
Gold plating
Gold plating
B32