Z22-020 Datasheet, PDF (5/5 Pages) Harwin Plc – 2mm Hand Crimp Tool

TOOL CALIBRATION
The operating force at the point shown should be 150N (15kg, 33lbs) min.
40mm
If adjustment of the tool becomes necessary due to pull-off forces not being maintained,
the following instructions should be followed.
1. Remove allen grub screw using a 2mm A/F allen key.
2. Using a screwdriver, turn the numbered wheel via the wheel adjustment screw. To
increase the pre-load (and therefore the crimp pull-off force), turn the screw until
the next number is shown. Even numbers are found by turning the screw clockwise,
odd numbers are anti-clockwise. Turn the screw until the required number is level
with the allen grub screw hole.
22-020
M22-305
M22-308
M22-308
Allen grub screw
5
Wheel adjustment screw
3. Re-fit the allen grub screw and tighten.
4. Check the operating force as shown at the top of the page. Repeat the procedure if
the force is incorrect.
If the adjuster is set to maximum, and operating force is still not
achieved, the tool has finished its working life (50,000 crimps minimum),
and will need replacing.
Side 4
IS-05 Issue: 2 Date: 09.01.01 C/Note: 5684