Z22-020 Datasheet, PDF (3/5 Pages) Harwin Plc – 2mm Hand Crimp Tool

TOOL DESCRIPTION
The Z22-020 Hand Crimp Tool consists of a ratchet mechanism hand tool and a set of
jaws. The jaws comprise of upper and lower crimp dies.
The contact is correctly crimped when the tool is free to open at the fully closed
position, i.e. when the ratchet releases.
CRIMPING PROCEDURE
1. Ensure that the wire to be crimped is within the specified range of sizes for the
contact and the crimp tool. Failure to use the specified wire size will result in poor
quality crimps and possible tool damage.
Wire Gauge
30 AWG
28 AWG
26 AWG
24 AWG
Minimum pull-off force (Newtons)
6N
11N
18N
29N
2. Strip the wire insulation to the dimensions shown below. Care should be taken to
avoid cutting or displacing the conductors. If the conductors are displaced, they
may be re-aligned with a gentle twist.
1.0mm max (M 22-304/5)
1.5mm max (M 22-306/8)
Ø1.4mm max
3. Make certain that the hand crimp tool is in the fully open position, and that the jaws
are free from dirt and debris.
4. If the socket is on a reel, break or cut off a contact from the strip of bandolier.
5. Place the contact into the correct crimp cavity in the fixed jaw. The markings on the
jaw indicate the correct crimp cavity according to the wire size being used. The
orientation of the contact is with the crimp end uppermost, with the open side of the
crimp facing towards the moving jaw.
Side 2
IS-05 Issue: 2 Date: 09.01.01 C/Note: 5684