S9132_15 Datasheet, PDF (9/10 Pages) Hamamatsu Corporation – High-speed frame rate sensor capable of acquiring two-dimensional projection data

Profile sensor
S9132
Precautions
(1) Electrostatic countermeasures
This device has a built-in protection circuit against static electrical charges. However, to prevent destroying the device with electro-
static charges, take countermeasures such as grounding yourself, the workbench and tools to prevent static discharges.
Also protect this device from surge voltages which might be caused by peripheral equipment.
(2) Incident window
If dust or dirt gets on the light incident window, it will show up as black blemishes on the image. When cleaning, avoid rubbing the
window surface with dry cloth or dry cotton swab, since doing so may generate static electricity. Use soft cloth, paper or a cotton
swab moistened with alcohol to wipe dust and dirt off the window surface. Then blow compressed air onto the window surface so
that no spot or stain remains.
(3) Soldering by hand
To prevent damaging the device during soldering, take precautions to prevent excessive soldering temperatures and times.
Soldering should be performed within 5 seconds at a soldering temperature below 260 °C.
(4) Reflow soldering
Soldering conditions may differ depending on the board size, reflow furnace, etc. Check the conditions before soldering. A sudden
temperature rise and cooling may be the cause of trouble, so make sure that the temperature change is within 4 °C per second.
The bonding portion between the ceramic base and the glass may discolor after reflow soldering, but this has no adverse effects on
the hermetic sealing of the product.
(5) UV exposure
This product is not designed to prevent deterioration of characteristics caused by UV exposure, so do not expose it to UV light.
Recommended temperature profile of reflow soldering (typical example)
300
Peak temperature 240 °C max.
250
200
150
100
50
0
0
50
100 150 200 250 300
Time (s)
KAPDB0169EA
9