S9132 Datasheet, PDF (3/6 Pages) Hamamatsu Corporation – Profile sensor High-speed frame rate sensor capable of acquiring two-dimensional projection data

s Spectral response (typical example)
(Ta=25 ˚C)
100
80
60
40
20
0
200 300 400 500 600 700 800 900 1000 1100 1200
WAVELENGTH (nm)
KMPDB0231EA
s A/D converter characteristics (Ta=25 °C)
Parameter
Symbol
Digital output format
Resolution *¹⁰
10-bit MODE
8-bit MODE
RESO
Conversion time
tCON
Frame readout time
FR
Conversion voltage range *¹¹
*10: Vsel=5 V (10-bit mode), Vsel=0 V (8-bit mode)
*11: Digital output is available from MSB as serial output.
10-bit mode: D9 to D0
8-bit mode: D7 to D0
s Timing chart
tr (CLK)
CLK
tf (ST)
ST
tf (CLK)
tpw (CLK)
tr (ST)
Profile sensor S9132
Value
Unit
Serial output
10
8
bit
12/f (CLK)
s/ch
3100/f (CLK)
s/f
0 to 3.8
V
DO
TRIG
KMPDC0177EA
Parameter
Symbol
Min.
Typ.
Max.
Unit
Clock pulse width
tpw (CLK)
40
-
-
ns
Clock pulse rise and fall time
tr (CLK), tf (CLK)
0
20
30
ns
Start pulse width
tpw (ST)
90
-
-
ns
Start pulse rise and fall time
tr (ST), tr (ST)
0
20
30
ns
NOTE) Operation in the X and Y directions can be performed independently.
The internal timing circuit starts operating at the fall timing of the clock pulse immediately after the start pulse goes "low".
It doesn’t matter how many times the clock pulse goes “low” during the "Low" period of the start pulse.
The storage time is determined by the start pulse intervals. However, scince the charge storage of each pixel is carried
out between the signal readout of that pixel and the next signal readout of the same pixel, the start time of charge storage
differs depending on each pixel. In addition, the next start pulse cannot be input until signal readout from all pixels is
completed.
3