C7557-01_15 Datasheet, PDF (3/7 Pages) Hamamatsu Corporation – For control of multichannel detector head and data acquisition

Multichannel detector head controller
C7557-01
Software
Parameter
Compatible OS
Specification
Windows 7 (32-bit, 64-bit)/
Windows 8 (64-bit)/
Windows 8.1 (64-bit)
Prepare a BNC cable in the following cases:
· Measurements by external sync
· Controlling an external shutter or external light source
· Measuring the video signal
Operation method
1. Make connections as indicated in  to .
 LINE
Connect to the power cable.
 USB
Connect to a computer through the USB cable.
 TE CONTROL I/O
Connect to the “TE CONTROL I/O” terminal on the detector head.
 SIGNAL I/O
Connect to the “I/O SIGNAL” terminal on the detector head.
 GND
When a 2-pin AC plug is used with the power cable, use this GND connector to ground the unit.
2. When all the connections are complete, turn on the power to the C7557-01.
3. Install the MCD USB driver and softeware. (For details on the MCD USB driver and software, refer to the operation manual supplied in
the package.)
POWER
SIGNAL I/O
LINE
TRIG.IN
PULSE OUT
VIDEO OUT
SYNC.OUT
TE CONTROL I/O
RS-232C
USB ID
USB
Front view
Rear view
KACCC0403EA
3