C7557-01_15 Datasheet, PDF (2/7 Pages) Hamamatsu Corporation – For control of multichannel detector head and data acquisition

Multichannel detector head controller
C7557-01
Precaution for use
When operating the NMOS multichannel detector head, always be sure to attach the MOS adapter (supplied with the C7557-01) to the
C7557-01 main unit. If the the NMOS multichannel detector head is connected and the power is turned on without attaching the adapter,
the power supply in the C7557-01 main unit may be damaged.
Functions
Parameter
Specification
Data transfer
Transfers data stored in memory to computer.
Exposure time setting
1 ms to 65535 ms (1 ms steps)
Minimum exposure time depends on sensor detection level.
External sync signal input
BNC connector input
Trigger mode
Internal sync, external sync
Trigger polarity
Trigger polarity selectable for external sync
Shutter timing pulse output
Outputs timing signal for operating external shutter or external light source via BNC connector.
Pulse width, delay and polarity settings are possible.
Video signal output
Outputs video signal sent from head, via BNC connector
Video sync signal output
Amplifier gain
Outputs sync signal used to observe video signal output with external device such as
oscilloscope, via BNC connector
1/2, 1, 2, 5, 10, 20, 50, 100*³
Image sensor and detector head
Compatible with each multichannel detector head
combination
Refer to “Selection guide for image sensor and detector head combination”
Detector cooling control
Cooling start and stop
Detector cooling temperature readout
Converts analog temperature data from detector into digital signal, and transfers it to computer.
(10-bit A/D conversion)
*3: Depending on the drive conditions, normal output may not be obtained if the amplifier gain is set too high. In this case, lower the
amplifier gain.
Specifications
A/D converter
Parameter
A/D converter
Conversion speed
Input range
Input method
Nonlinear linearity
A/D conversion signal
CCD area
image sensor
16 bits
4 μs/ch
0 to 10 V
NMOS linear
image sensor
InGaAs linear image sensor
16 bits
24 μs/ch
12 bits
2 μs/ch
16 bits
8 μs/ch
0 to 10 V
-10 to +10 V
Differential input
0.1%FS
External input
Controller
Parameter
Clock
Memory
Interface
Specification
20 MHz
4 MB (1024 ch × 2048 lines)
USB 2.0/3.0
Equipment
Parameter
Interface
Power supply
Power consumption
Dimension (W × H × D)
Operating temperature
Storage temperature
Weight
Specification
USB 2.0/3.0 Type B connector
AC100 to 240 V ± 10%, 50 to 60 Hz
50 V · A typ.
92 × 150 × 226 mm
0 to 40 °C
-10 to 50 °C
Approx. 2.5 kg
2