|
GS81302D07E-333 Datasheet, PDF (7/31 Pages) GSI Technology – JEDEC-standard pinout and package | |||
|
◁ |
GS81302D07/10/19/37E-450/400/350/333/300
Background
Separate I/O SRAMs, from a system architecture point of view, are attractive in applications where alternating reads and writes are
needed. Therefore, the SigmaQuad-II+ SRAM interface and truth table are optimized for alternating reads and writes. Separate I/O
SRAMs are unpopular in applications where multiple reads or multiple writes are needed because burst read or write transfers from
Separate I/O SRAMs can cut the RAMâs bandwidth in half.
SigmaQuad-II+ B4 SRAM DDR Read
The status of the Address Input, W, and R pins are sampled by the rising edges of K. W and R high causes chip disable. A Low on
the Read Enable pin, R, begins a read cycle. R is always ignored if the previous command loaded was a read command. Clocking
in a High on the Read Enable pin, R, begins a read port deselect cycle.
SRAM DDR Write
The status of the Address Input, W, and R pins are sampled by the rising edges of K. W and R High causes chip disable. A Low on
the Write Enable pin, W, and a High on the Read Enable pin, R, begins a write cycle. W is always ignored if the previous command
was a write command. Data is clocked in by the next rising edge of K, the rising edge of K after that, the next rising edge of K, and
finally by the next rising edge of K.
Special Functions
Byte Write and Nybble Write Control
Byte Write Enable pins are sampled at the same time that Data In is sampled. A High on the Byte Write Enable pin associated with
a particular byte (e.g., BW0 controls D0âD8 inputs) will inhibit the storage of that particular byte, leaving whatever data may be
stored at the current address at that byte location undisturbed. Any or all of the Byte Write Enable pins may be driven High or Low
during the data in sample times in a write sequence.
Each write enable command and write address loaded into the RAM provides the base address for a 4-beat data transfer. The x18
version of the RAM, for example, may write 72 bits in association with each address loaded. Any 9-bit byte may be masked in any
write sequence.
Nybble Write (4-bit) control is implemented on the 8-bit-wide version of the device. For the x8 version of the device, âNybble
Write Enableâ and âNWxâ may be substituted in all the discussion above.
Example x18 RAM Write Sequence using Byte Write Enables
Data In Sample Time
BW0
BW1
Beat 1
0
1
Beat 2
1
0
Beat 3
0
0
Beat 4
1
0
D0âD8
Data In
Donât Care
Data In
Donât Care
Resulting Write Operation
Byte 1
D0âD8
Byte 2
D9âD17
Written
Unchanged
Beat 1
Byte 1
D0âD8
Byte 2
D9âD17
Unchanged
Written
Beat 2
Byte 1
D0âD8
Byte 2
D9âD17
Written
Written
Beat 3
D9âD17
Donât Care
Data In
Data In
Data In
Byte 1
D0âD8
Byte 2
D9âD17
Unchanged
Written
Beat 4
Rev: 1.04b 8/2017
7/31
Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.
© 2011, GSI Technology
|
▷ |