GS8180QV18BGD-200 Datasheet, PDF (21/28 Pages) GSI Technology – 18Mb Burst of 2 SigmaQuad SRAM

GS8180QV18/36BD-200/167
device pins and the bits in the Boundary Scan Register is described in the Scan Order Table following. The Boundary Scan
Register, under the control of the TAP Controller, is loaded with the contents of the RAMs I/O ring when the controller is in
Capture-DR state and then is placed between the TDI and TDO pins when the controller is moved to Shift-DR state. SAMPLE-Z,
SAMPLE/PRELOAD and EXTEST instructions can be used to activate the Boundary Scan Register.
JTAG TAP Block Diagram
····· ···
Boundary Scan Register
·
·
·
0
Bypass Register
210
Instruction Register
TDI
TDO
ID Code Register
· 31 30 29 · · · 2 1 0
Control Signals
TMS
TCK
Test Access Port (TAP) Controller
Identification (ID) Register
The ID Register is a 32-bit register that is loaded with a device and vendor specific 32-bit code when the controller is put in
Capture-DR state with the IDCODE command loaded in the Instruction Register. The code is loaded from a 32-bit on-chip ROM.
It describes various attributes of the RAM as indicated below. The register is then placed between the TDI and TDO pins when the
controller is moved into Shift-DR state. Bit 0 in the register is the LSB and the first to reach TDO when shifting begins.
ID Register Contents
Not Used
GSI Technology
JEDEC Vendor
ID Code
Bit # 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
X X X X X X X X X X X X X X X X X X X X 0 0 011011001 1
Rev: 1.02b 11/2011
21/28
Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.
© 2007, GSI Technology