YB15SKW01-12-CB Datasheet, PDF (2/9 Pages) GREATECS – Short Body Pushbuttons

Illuminated Switches
Short Body Pushbuttons
YB Series
General Specifications
Electrical Capacity (Resistive Load)
Power Level (silver): 3A @ 125V AC or 3A @ 250V AC or 3A @ 30V DC
Logic Level (gold): 0.4VA maximum @ 28V AC/DC maximum
(Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)
Note: Find additional explanation of operating range in
Other Ratings
Supplement section.
Contact Resistance: 50 milliohms maximum for silver; 100 milliohms maximum for gold
Insulation Resistance: 200 megohms minimum @ 500V DC
Dielectric Strength: 1,000V AC minimum between contacts for 1 minute minimum;
1,500V AC minimum between contacts & case for 1 minute minimum
Mechanical Life: 1,000,000 operations minimum for momentary circuit
200,000 operations minimum for maintained circuit
Electrical Life: 100,000 operations minimum
Nominal Operating Force: ^{Single pole: 1.47N for nonsealed; 1.67N for sealed}
Double pole: 2.75N for nonsealed; 2.94N for sealed
Contact Timing: Nonshorting (break-before-make)
Travel: Pretravel .059” (1.5mm); Overtravel .059” (1.5mm); Total Travel .118” (3.0mm)
Materials & Finishes
Housing/Bezel:
Snap-in Frame:
Base:
Movable Contactor:
Movable Contacts:
Stationary Contacts:
Switch Terminals:
Lamp Terminals:
Glass fiber reinforced polyamide (UL94V-0)
Stainless steel
Diallyl phthalate resin (UL94V-0)
Phosphor bronze with silver or gold plating
Silver alloy with silver plating or brass with gold plating
Silver alloy or copper with gold plating
Phosphor bronze with tin plating
Phosphor bronze with tin plating
Environmental Data
Operating Temp Range:
Humidity:
Vibration:
Shock:
Sealing:
–25°C through +50°C (–13°F through +122°F)
Note: When used with a polyvinyl chloride splash cover, the
lowest limit is 0°C (32°F)
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the
frequency range & returning in 1 minute; 3 right angled
directions for 2 hours
50G (490m/s ²) acceleration (tested in 6 right angled directions,
with 5 shocks in each direction)
IP65 of IEC60529 standard for panel seal models
Installation
Mounting Torque:
Soldering Time & Temperature:
0.785Nm (6.95 lb t in) maximum
Manual Soldering: See Profile A in Supplement section.
Standards & Certifications
Flammability Standards:
UL & C-UL Recognized:
CSA Certified:
UL94V-0 housing & base
All models recognized at 3A @ 125V or 250V AC or 0.4VA
@ 28V AC/DC maximum;
UL File No. WOYR2.E44145; add “/U” to end of part number
to order UL mark on switch.
UL File No. WOYR8.E44145; add “/C-UL” to end of part number
to order C-UL mark on switch.
All solder models certified at 3A @125V or 250V AC or 0.4VA @ 28V
AC/DC maximum;
CSA File Nos. 023535-0-000; add “/C” to end of part number to
order CSA mark on switch.
[e-mail]
www.greatecs.com 2