XAL-53 Datasheet, PDF (2/2 Pages) Gamewell-FCI by Honeywell – Explosion-Proof Pull Station

OPERATIONAL DATA
This enclosure is made of cast, copper-free aluminum al-
loy. It is suitable for: Class I, Groups C and D; Class II,
Groups E, F, and G; and Class III hazardous locations. All
installations must comply with applicable local and/or Na-
tional Electrical Code.
During installation, DO NOT use looped wire under ter-
minals. Break wire run to provide supervision of con-
nections.
Like all electromechanical devices, these control stations
require occasional maintenance. Parts may wear out or
become defective due to adverse environmental conditions.
See Maintenance Data below.
MAINTENANCE DATA
Disconnect this device from the supplying circuit be-
fore removing the cover.
1) To prevent corrosion, lubricant should be occasionally
applied, as follows:
• Killark® “LUBG” lubricant to box/cover flanges.
• Dow Corning® Molykote® 33 Grease, light consistency,
to operator shaft.
2) Keep all flanges clean and free of scratches.
3) Some internal service parts are available. Consult the
Killark® factory for parts breakdowns.
KILLARK® is a registered trademark of Hubbell®. Dow Corn-
ing® and Molykote® are registered trademarks of Dow Corn-
ing Corporation.
PRODUCT LINE INFORMATION
XAL-53 Pull station, explosion-proof, N/O and N/C con-
tacts.
SBA-10 Backbox.
CONTACT ARRANGEMENT
NOT ACTIVATED
POSITION
5274con1.wmf
ACTIVATED
POSITION
5274con2.wmf
Page 2 of 2 — CS-2506 • 09/01/06