MB15F73UV Datasheet, PDF (7/25 Pages) Fujitsu Component Limited. – Dual Serial Input PLL Frequency Synthesizer

MB15F73UV
(Continued)
Parameter
Symbol
Condition
(VCC = 2.4 V to 3.6 V, Ta = −40 °C to +85 °C)
Value
Unit
Min
Typ
Max
“H” level output DoIF *⁸
current
DoRF
IDOH *⁴
VCC = 2.7 V,
VDOH = Vcc / 2,
Ta = +25 °C
CS bit = “1”
−8.2
−6.0
−4.1 mA
CS bit = “0”
−2.2
−1.5
−0.8 mA
“L” level output DoIF *⁸
current
DoRF
VCC = 2.7 V,
IDOL VDOL = Vcc / 2,
Ta = +25 °C
CS bit = “1”
4.1
CS bit = “0”
0.8
6.0
1.5
8.2 mA
2.2 mA
Charge pump
current rate
IDOL/IDOH IDOMT *⁵
vs VDO IDOVD *⁶
vs Ta IDOTA *⁷
VDO = Vcc / 2
0.5 V ≤ VDO ≤ Vcc − 0.5 V
−40 °C ≤ Ta ≤ +85 °C,
VDO = Vcc / 2

3

%

10

%

5

%
*1 : Conditions ; fosc = 12.8 MHz, Ta = +25 °C, SW = “0” in locking state.
*2 : VCCIF = VCCRF = 2.7 V, fosc = 12.8 MHz, Ta = +25 °C, in power saving mode.
PSIF = PSRF = GND
VIH = VCC, VIL = GND (at CLK, Data, LE)
*3 : AC coupling. 1000 pF capacitor is connected under the condition of Min operating frequency.
*4 : The symbol “–” (minus) means the direction of current flow.
*5 : VCC = 2.7 V, Ta = +25 °C (||I3| − |I4||) / [ (|I3| + |I4|) / 2] × 100 (%)
*6 : VCC = 2.7 V, Ta = +25 °C [ (||I2| − |I1||) / 2] / [ (|I1| + |I2|) / 2] × 100 (%) (Applied to both lDOL and lDOH)
*7 : VCC = 2.7 V, [||IDO (+85 °C) | − |IDO (–40 °C) || / 2] / [|IDO (+85 °C) | + |IDO (–40 °C) | / 2] × 100 (%) (Applied to both IDOL and IDOH)
*8 : When Charge pump current is measured, set LDS = “0” , T1 = “0” and T2 = “1”.
I1
I3
IDOL
I2
IDOH
I2
I4
I1
0.5
VCC/2 VCC − 0.5 VCC
Charge pump output voltage (V)
7